C9 Engine For Caterpillar Built Machines Caterpillar


Fuel Transfer Pump - Install

Usage:

TK711 101

安装步骤

表 1
所需工具    
工具     零件号     零件说明     数量    
(1)     218-8171     螺栓     1    
( 1 ) 218-8172 燃油输油泵和安装件总成 部分


注意

保持所有零件清洁无杂质。

杂质会造成快速磨损和缩短部件寿命。


  1. 彻底清洁部件和配合面。



    图 1g01032028

  1. 将燃油输送泵 (4) 定位到单体喷油器液压泵 (1) 上。 确保将燃油输油泵的驱动舌片对准泵轴端部的驱动槽。

  1. 安装螺栓 (3) 。 此时略微拧紧螺栓。

  1. 拆下工具 (A) ,并安装剩余螺栓 (2) 。 此时略微拧紧螺栓。

  1. 安装燃油输送泵 (4) 的安装螺栓 (5) 。 此时略微拧紧螺栓。

  1. 将螺栓 (2) 和 (3) 均匀上紧到 28 ± 2 N·m (21 ± 1 lb ft) 的扭矩。

  1. 将螺栓 (2) 和 (3) 重新上紧到 28 ± 2 N·m (21 ± 1 lb ft) 的扭矩。

  1. 拧紧螺栓 (5) ,使其扭矩达到 8.0 ± 0.4 N·m (71 ± 4 lb in)。

End By: 安装单体喷油器液压泵。 请参阅 拆解和组装, "单体喷油器液压泵 - 安装"。

Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.