Speed Sensor
Show/hide table
Illustration 1 | g03137348 |
Show/hide table
Specification for 9X-5392 Speed Sensor Gp | |||
Item | Qty | Part | Specification Description |
1 | 1 | - | Use the following procedure in order to tighten the speed sensor: 1. Install the speed sensor into the threaded hole and turn until the sensor tip contacts the tooth of the flywheel ring gear. 2. Back out 180 degrees and tighten the locknut. 3. Tighten the nut to |
- | - | - | The clearance between the speed sensor and the flywheel ring gear is |
Caterpillar Information System:
584 and 584HD Forwarders Guards - Operator Protection
3456 Generator Sets Generator Lead Connections
3406E Marine Engine Gear Group (Front) - Remove
C3.3 Industrial Engine Water Pump - Remove
Electronic Modular Control Panel II (EMCP II) General Information
795F and 795F AC XQ Off-Highway Truck Steering System Pressure Sensor (Steering Accumulator)
C9 Engine For Caterpillar Built Machines Fuel Transfer Pump - Install
C9 Engine For Caterpillar Built Machines Fuel Transfer Pump - Remove
C9 Marine Engines and C9 Marine Generator Sets Coolant Level Sensor - Remove and Install
3516B HD Generator Set After Starting Engine
EMCP3 Electronic Control Module (Generator Set)
EMCP3 Setpoint Programming
Welding Repair of Motor Grader Frame {0679, 7051} Welding Repair of Motor Grader Frame {0679, 7051}
G3500 Engines Air Starting Motor - Malfunction
G3500 Engines Coolant Level Sensor - Coolant Level Switch
3408E and 3412E Engines for Caterpillar Built Machines Unit Injector
G3500 Engines Alternator - Malfunction
G3500 Engines Coolant in Engine Oil
G3500 Engines Detonation
G3500 Engines Engine Cranks but Will Not Start
G3500 Engines Engine Has Early Wear
G3500 Engines Engine Misfires, Runs Rough or Is Unstable
G3500 Engines Engine Oil in Cooling System
C9 Marine Engines and C9 Marine Generator Sets Rocker Arm and Shaft - Remove