Engine Oil Cooler - Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | - | Guide Stud (M8 x 1.25 x 70 mm) |
2 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install Tooling (A) in the cylinder block.
- Install gasket (8) and oil cooler core assembly (7) on Tooling (A).
Show/hide table
Illustration 2 g01109765 - Install gasket (4) and engine oil filter base (1) on Tooling (A). Install bolts (2) finger tight.
- Remove Tooling (A) and install remaining bolts (2) finger tight.
- Tighten bolts (2) in a numerical sequence to a torque of
35 ± 8 N·m (26 ± 6 lb ft) . - Install tube assembly (5) and tube assembly (6). Install the clamps and tighten the nuts to a torque of
30 ± 7 N·m (22 ± 5 lb ft) . - Connect tube assembly (3).
- Fill the lubrication system with engine oil. Refer to Operation and Maintenance Manual, "Refill Capacities" for the lubrication system capacity of the engine.
Show/hide table
Illustration 1 | g01109764 |
End By:
- Install the marine transmission oil cooler. Refer to Disassembly and Assembly , "Marine Transmission Oil Cooler - Remove and Install".
- Install the heat exchanger. Refer to Disassembly and Assembly , "Heat Exchanger - Install".
Caterpillar Information System:
C9 Marine Engines and C9 Marine Generator Sets Engine Oil Cooler - Remove
C9 Marine Auxiliary and Generator Set Engines Fuel Conservation Practices
C7 On-highway Engine Inlet Air Temperature Sensor - Remove and Install
3408C, 3412C and 3412D High Performance Marine Engines Cooling System - Inspect
3408C, 3412C and 3412D High Performance Marine Engines Cooling System - Test
3408C, 3412C and 3412D High Performance Marine Engines Charging System - Test
C7 On-highway Engine Boost Pressure Sensor - Remove and Install
3408C, 3412C and 3412D High Performance Marine Engines Piston Ring Groove - Inspect
C7 On-highway Engine Injection Actuation Pressure Sensor - Remove and Install
3408C, 3412C and 3412D High Performance Marine Engines Fuel System Pressure - Test
3408C, 3412C and 3412D High Performance Marine Engines Fuel System - Inspect
C7 On-highway Engine Engine Oil Pressure Sensor - Remove and Install
C9 Marine Engines and C9 Marine Generator Sets Marine Transmission Oil Cooler - Remove and Install
C9 Marine Engines and C9 Marine Generator Sets Engine Oil Pump - Remove
C9 Marine Engines and C9 Marine Generator Sets Engine Oil Pump - Install
3408C, 3412C and 3412D High Performance Marine Engines Air Inlet and Exhaust System
3516B HD Generator Set Cold Weather Operation
C15 and C18 Petroleum Generator Sets Before Starting Engine
C9 Marine Auxiliary and Generator Set Engines Starting the Engine
C9 Marine Auxiliary and Generator Set Engines Cold Weather Starting
C9 Marine Engines and C9 Marine Generator Sets Electric Starting Motor - Remove and Install
EMCP3 Setpoint Programming
EMCP3 Electronic Control Module (Generator Set)
3516B HD Generator Set After Starting Engine