Engine Oil Cooler - Remove
Start By:
- Remove the heat exchanger. Refer to Disassembly and Assembly , "Heat Exchanger - Remove".
- Remove the marine transmission oil cooler. Refer to Disassembly and Assembly , "Marine Transmission Oil Cooler - Remove and Install".
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove tube assembly (5) and tube assembly (6).
- Disconnect tube assembly (3).
- Remove bolts (2).
- Remove engine oil filter base (1). Remove gasket (4) from the engine oil filter base.
Show/hide table
Illustration 2 g01109756 - Remove oil cooler core assembly (7) from the cylinder block. Remove gasket (8) from the oil cooler core assembly.
Show/hide table
| |
| Illustration 1 | g01109744 |
Caterpillar Information System:
C9 Marine Auxiliary and Generator Set Engines Fuel Conservation Practices
C7 On-highway Engine Inlet Air Temperature Sensor - Remove and Install
3408C, 3412C and 3412D High Performance Marine Engines Cooling System - Inspect
3408C, 3412C and 3412D High Performance Marine Engines Cooling System - Test
3408C, 3412C and 3412D High Performance Marine Engines Charging System - Test
C7 On-highway Engine Boost Pressure Sensor - Remove and Install
3408C, 3412C and 3412D High Performance Marine Engines Piston Ring Groove - Inspect
C7 On-highway Engine Injection Actuation Pressure Sensor - Remove and Install
3408C, 3412C and 3412D High Performance Marine Engines Fuel System Pressure - Test
3408C, 3412C and 3412D High Performance Marine Engines Fuel System - Inspect
C7 On-highway Engine Engine Oil Pressure Sensor - Remove and Install
C9 Marine Auxiliary and Generator Set Engines Reference Material
C9 Marine Engines and C9 Marine Generator Sets Engine Oil Cooler - Install
C9 Marine Engines and C9 Marine Generator Sets Marine Transmission Oil Cooler - Remove and Install
C9 Marine Engines and C9 Marine Generator Sets Engine Oil Pump - Remove
C9 Marine Engines and C9 Marine Generator Sets Engine Oil Pump - Install
3408C, 3412C and 3412D High Performance Marine Engines Air Inlet and Exhaust System
3516B HD Generator Set Cold Weather Operation
C15 and C18 Petroleum Generator Sets Before Starting Engine
C9 Marine Auxiliary and Generator Set Engines Starting the Engine
C9 Marine Auxiliary and Generator Set Engines Cold Weather Starting
C9 Marine Engines and C9 Marine Generator Sets Electric Starting Motor - Remove and Install
EMCP3 Setpoint Programming
EMCP3 Electronic Control Module (Generator Set)