Crankshaft Wear Sleeve (Front) - Remove
Start By:
- Remove the crankshaft pulley (1). Refer to this Disassembly and Assembly Manual, "Crankshaft Pulley - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove the crankshaft front seal (3). Refer to this Disassembly and Assembly Manual, "Crankshaft Front Seal - Remove". Discard the crankshaft front seal (3).
- If an existing crankshaft wear sleeve (front) (2) is installed onto the crankshaft pulley (1), remove the crankshaft wear sleeve (front). Install a deep score mark along the length of the crankshaft wear sleeve (front) (2).
- Insert a suitable tool between the crankshaft pulley (1) and the crankshaft wear sleeve (front) (2) next to the score mark. The crankshaft wear sleeve (front) (2) should break along the score mark.
- Use a suitable solvent in order to remove any old sealant from the crankshaft pulley (1).
Show/hide table
Illustration 1 | g01020971 |
Note: A new crankshaft front seal (3) must be installed when a new crankshaft wear sleeve (front) (2) is installed.
Caterpillar Information System:
C9 Industrial Engines Engine Oil Pressure Sensor
2003/12/01 A New Integral Seal Provides Improved Sealing {7555}
3508B, 3508C, 3512B, 3512C, 3516B and and 3516C Marine Engines Product Lifting
3508B, 3512B, and 3516B High Displacement Generator Sets Engine Stopping
3512C and 3516C Marine Auxiliary and Generator Set Engines Emergency Stopping
3508B, 3512B, and 3516B High Displacement Generator Sets Engine Electronics
3512C and 3516C Marine Auxiliary and Generator Set Engines Electrical System
2003/09/15 A New Integral Seal Provides Improved Sealing {7555}
C4.4 Industrial Engine Cooling System - Test
3606 and 3608 Engines Exhaust Manifold Shield - Remove and Install
Product Link MODEM Programming with Cat Electronic Technician (ET){7606, 7620} Product Link MODEM Programming with Cat Electronic Technician (ET){7606, 7620}
3508B, 3512B, 3516B, 3512C and and 3516C Auxiliary Engines, Generator Set Engines, and Generator Sets Safety Messages
C3.3 Industrial Engine Crankshaft Wear Sleeve (Front) - Install
C3.3 Industrial Engine Front Cover - Remove and Install
C3.3 Industrial Engine Housing (Front) - Remove
2003/11/01 The Alternator Guard has been Redesigned {7168}
2003/09/01 New Software Is Used on Product Link 151/201 {7606, 7620}
C15 On-Highway Engines Fuel System
2003/09/01 Improved Water Pump Seal {7555}
C15 and C18 Engines for Caterpillar Built Machines Water Pump - Assemble
C15 and C18 Engines for Caterpillar Built Machines Water Pump - Disassemble
C15 On-highway Engine Engine Support (Front) - Remove and Install
Troubleshooting Marine Engine Cooling Systems{1350} Troubleshooting Marine Engine Cooling Systems{1350}
C15 and C18 Engines for Caterpillar Built Machines General Information