Valve Actuator (Variable) - Install
安装步骤
- 将气门执行器(可变) (5) 安置在发动机上,然后安装螺栓 (3) 和螺母 (2) 。 拧紧螺栓 (3) 和螺母 (2) 至扭矩为 100 ± 20 N·m (75 ± 15 lb ft)。
Show/hide table
图 1 | g01315836 |
- 连接线束组件 (4) 和 (1) 。
- 调整可变气门执行器。 请参阅测试和调整, "可变气门执行器 - 检查/调整"。
End By: 安装气门机构盖。 请参阅 拆解和组装, "气门机构盖 - 拆卸和安装"。
Caterpillar Information System:
C11 and C13 Engines Valve Actuator (Variable) - Remove
C9 On-highway Engines California Emission Control Warranty Statement
2004/03/01 SOLAS Requirements For Oil Lines {1307}
C9 On-highway Engines Federal Emission Control Warranty
G3500B Engines Fuel Metering Valve - Check - Raptor
2003/08/01 Update Caterpillar Electronic Technician (Cat ET) to the Newest Version {0785}
G3500B Engines Engine Protective Devices - Check
C-15 On-Highway Engine Fuel Recirculation Valve - Remove and Install
G3500B Engines Engine Crankcase Breather - Clean
C11 and C13 Engines Precooler - Install
3408E and 3412E Engines for Caterpillar Built Machines Cylinder Block
C11 and C13 Engines Precooler - Remove
C11 and C13 Engines for Caterpillar Built Machines Gear Group (Front) - Remove
3512C and 3516C Marine Auxiliary and Generator Set Engines Gas Pressure Regulator Condensation - Drain
C11 and C13 Engines for Caterpillar Built Machines Gear Group (Front) - Install
G3520C and G3520E Generator Set Engines Component Location
C11 and C13 Engines for Caterpillar Built Machines Front Cover - Remove
2003/08/01 An Improved Stub Shaft is Used for Engines with Dual Vibration Dampers {1237, 5569}
C15 and C18 Engines for Caterpillar Built Machines Injector Solenoid Circuit - Test
C11 and C13 Engines for Caterpillar Built Machines Front Cover - Install
2003/09/01 Improved Pump Drive Gear for an Auxiliary Sea Water Pump {1242}
Customer Interface for the 3512B Well Fracturing Engine (ADEM II){1408} Customer Interface for the 3512B Well Fracturing Engine (ADEM II){1408}
C11 and C13 Engines for Caterpillar Built Machines Inlet and Exhaust Valve Seat Inserts - Remove and Install
G3406 Engines Engine Oil Pan