Removal Procedure
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| ZZ | 9U-7072 | Tapered Cap/Plug | 1 |
| 9U-7070 | Tapered Cap/Plug | 1 | |
Note: SERVICE DATA: TOOLING (ZZ) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Remove bolt (5). Remove clamp (4) .
 | |
| Illustration 1 | g00912394 |
- Disconnect tube assembly (1) from flow control valve (2) .
- Disconnect hose assembly (3) from flow control valve (2) .
- Remove the flow control valve.
Installation Procedure
- Connect flow control valve (2) to tube assembly (1) .
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
| | |
| Illustration 2 | g00912394 |
- Connect hose assembly (3) to flow control valve (2).
- Install clamp (4). Secure clamp (4) with bolt (5) .