Fuel Metering Valve - Check - Raptor
Show/hide table
Illustration 1 | g01090000 |
For information regarding the fuel metering valve, refer to Installation and Operation Manual, SEBU7630, "Raptor Gas Regulation and Metering Valve/Actuator System for Caterpillar".
Caterpillar Information System:
2003/08/01 Update Caterpillar Electronic Technician (Cat ET) to the Newest Version {0785}
G3500B Engines Engine Protective Devices - Check
C-15 On-Highway Engine Fuel Recirculation Valve - Remove and Install
G3500B Engines Engine Crankcase Breather - Clean
C11 and C13 Engines Precooler - Install
3408E and 3412E Engines for Caterpillar Built Machines Cylinder Block
C11 and C13 Engines Precooler - Remove
G3406 Engines Camshaft
2003/08/01 Diagnosis of Failure of Exhaust Valve {1105}
C11 and C13 Engines Diverter Valve (Coolant) - Install
C27 and C32 Generator Set Engines Camshaft Bearings - Install
C27 and C32 Generator Set Engines Camshaft Bearings - Remove
C9 On-highway Engines Federal Emission Control Warranty
2004/03/01 SOLAS Requirements For Oil Lines {1307}
C9 On-highway Engines California Emission Control Warranty Statement
C11 and C13 Engines Valve Actuator (Variable) - Remove
C11 and C13 Engines Valve Actuator (Variable) - Install
C11 and C13 Engines for Caterpillar Built Machines Gear Group (Front) - Remove
3512C and 3516C Marine Auxiliary and Generator Set Engines Gas Pressure Regulator Condensation - Drain
C11 and C13 Engines for Caterpillar Built Machines Gear Group (Front) - Install
G3520C and G3520E Generator Set Engines Component Location
C11 and C13 Engines for Caterpillar Built Machines Front Cover - Remove
2003/08/01 An Improved Stub Shaft is Used for Engines with Dual Vibration Dampers {1237, 5569}
C15 and C18 Engines for Caterpillar Built Machines Injector Solenoid Circuit - Test