Turbocharger - Install
Installation Procedure
Show/hide table
Required Tools     | |||
---|---|---|---|
Tool     | Part Number     | Part Description     | Qty     |
A     | 5P-3931     | Anti-Seize Compound     | 1     |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Inspect the turbocharger gasket for wear or damage. If the turbocharger gasket is worn or damaged, use a new part for replacement.
- Apply Tooling (A) on the threads of the mounting studs for the turbocharger.
- Position the turbocharger gasket and turbocharger (3) on the exhaust manifold. Install nuts (1) that fasten turbocharger (3) to the exhaust manifold.
Show/hide table
Illustration 1 | g01031222 |
- Tighten the locknuts that fasten the turbocharger to the exhaust manifold.
Tighten the 3E-8017 Locknut with the Spiralock thread to the following torque: ... 54 ± 5 N·m (40 ± 4 lb ft)
Tighten the standard 9X-6620 Locknut to the following torque: ... 70 ± 5 N·m (50 ± 4 lb ft)
- Connect tube assembly (2) and tube assembly (4) .
Caterpillar Information System:
C7 Engines for Combat and Tactical Vehicles Engine Oil Level Gauge - Calibrate
C7 On-highway Engine Turbocharger - Remove
C15 and C18 Petroleum Generator Sets Parallel Operation
3512C HD SR500 Generator Sets Single Unit Operation
120H and 135H Motor Graders Machine Systems Metering Pump (Steering) - Remove and Install
2003/07/01 Identifying the Prelube Circuit and the Air Start Circuit {1408}
2003/10/01 Policy for Reusing the Turbocharger Turbine Housing {1052, 1065, 7754}
2003/07/01 Replacement of the ECM for Heavy-Duty On-Highway Engines {1901}
3508C, 3512C and 3516C Marine Engines Auxiliary Water Pump - Install
Cat® Digital Voltage Regulator Remote Communication
C11, C13 and C15 On-highway Engines Input Selections
C11, C13 and C15 On-highway Engines Vehicle Speed Parameters
C7 On-highway Engine Cylinder Head - Remove
C7 On-highway Engine Cylinder Head - Install
C7 On-highway Engine Electronic Control Module - Remove and Install
2003/07/01 Quality of Remanufactured Camshafts {1210}
C11, C13 and C15 On-highway Engines 0283-07 Intake Valve Actuation Oil Pressure not responding (91)
C11 and C13 Engines Electronic Unit Injector - Remove
C11 and C13 Engines Electronic Unit Injector - Install
C11 and C13 Engines Rocker Shaft and Pushrod - Remove
C11 and C13 Engines Rocker Shaft and Pushrod - Install
C11 and C13 Engines Fuel Filter Base - Remove and Install
C11 and C13 Engines for Caterpillar Built Machines Fuel Transfer Pump - Remove
C11 and C13 Engines for Caterpillar Built Machines Fuel Transfer Pump - Install