Electronic Control Module - Remove and Install
Removal Procedure
- Remove covers (1) from electronic control module (2) .
Show/hide table
Illustration 1 | g01030211 |
- Loosen screw (4) until harness assembly (3) can be disconnected. Disconnect harness assembly (3) .
Show/hide table
Illustration 2 | g01030212 |
- Remove bolts (5), the washers, and the rubber mounts. Remove electronic control module (2) from the engine.
Installation procedure
- Position electronic control module (2) on the engine and install the rubber mounts, the washers, and bolts (5) .
Show/hide table
Illustration 3 | g01030212 |
- Connect harness assembly (3). Tighten screw (4) to a torque of 6 ± 1 N·m (53 ± 9 lb in).
- Install covers (1) on electronic control module (2) .
Show/hide table
Illustration 4 | g01030211 |
Caterpillar Information System:
C7 On-highway Engine Cylinder Head - Install
C7 On-highway Engine Cylinder Head - Remove
C7 On-highway Engine Turbocharger - Install
C7 Engines for Combat and Tactical Vehicles Engine Oil Level Gauge - Calibrate
C7 On-highway Engine Turbocharger - Remove
C15 and C18 Petroleum Generator Sets Parallel Operation
3512C HD SR500 Generator Sets Single Unit Operation
120H and 135H Motor Graders Machine Systems Metering Pump (Steering) - Remove and Install
2003/07/01 Identifying the Prelube Circuit and the Air Start Circuit {1408}
2003/10/01 Policy for Reusing the Turbocharger Turbine Housing {1052, 1065, 7754}
2003/07/01 Replacement of the ECM for Heavy-Duty On-Highway Engines {1901}
3508C, 3512C and 3516C Marine Engines Auxiliary Water Pump - Install
2003/07/01 Quality of Remanufactured Camshafts {1210}
C11, C13 and C15 On-highway Engines 0283-07 Intake Valve Actuation Oil Pressure not responding (91)
C11 and C13 Engines Electronic Unit Injector - Remove
C11 and C13 Engines Electronic Unit Injector - Install
C11 and C13 Engines Rocker Shaft and Pushrod - Remove
C11 and C13 Engines Rocker Shaft and Pushrod - Install
C11 and C13 Engines Fuel Filter Base - Remove and Install
C11 and C13 Engines for Caterpillar Built Machines Fuel Transfer Pump - Remove
C11 and C13 Engines for Caterpillar Built Machines Fuel Transfer Pump - Install
C4.4 (Mech) Industrial Engine Electrical System
G3520C and G3520E Generator Set Engines Valve Cover - Remove and Install
2003/11/01 New Unit Injector Rocker Arm Is Now Used {1123}