CID 0262 FMI 03 5 Volt Sensor DC Power Supply short to +batt
Conditions Which Generate This Code:
The Electronic Control Module (ECM) reads supply voltage that is above normal.
System Response:
The ECM will log the diagnostic code. The ECM flags all analog sensors as invalid data and default values are used.
- The engine may experience low power.
Test Step 1. Perform the following diagnostic procedure: Analog Sensor Supply Circuit - Test
Results:
- OK - STOP
Caterpillar Information System:
3126B and 3126E On-highway Engines 0252-11 Engine Software Incorrect (59)
793B Off-Highway Truck Suspension Cylinder Suspension Cylinder (Rear)
793B Off-Highway Truck Suspension Cylinder Suspension Cylinder (Front)
G3520C and G3520E Generator Set Engines Engine Monitoring System
3406E, C-10 and C-12 On-highway Engines 0190-00 Engine Overspeed Warning (35)
3406E, C-10 and C-12 On-highway Engines 0122-05 Med/High Retarder current low (14)
3406E, C-10 and C-12 On-highway Engines 0122-06 Med/High Retarder current high (14)
3126B and 3126E On-highway Engines 0043-02 Key Switch Fault (71)
C9 On-highway Engines Fuel System - Prime
120H and 135H Motor Graders Seat Belt
C7 and C9 On-Highway Engines 0042-11 Injection Actuation Pressure output fault
3406E, C-10 and C-12 On-highway Engines 0121-05 Low/High Retarder current low (14)
3406E, C12, C15 and C18 Marine Engines CID 0262 FMI 04 5 Volt Sensor DC Power Supply short to ground
C7 Engines for Combat and Tactical Vehicles 0253-02 Check Customer or System Parameters (56)
2002/11/01 Correction to Special Instruction , "Additional Information for the Customer Communication Module (CCM) that Is Used on Series 3500 and 3600 Gas Applications" {1926}
3054E Industrial Engine Glow Plugs - Test
3046 Engine for Caterpillar Built Machines Air Inlet and Exhaust System - Inspect
3054E Industrial Engine Engine Valve Lash - Inspect/Adjust
584 and 584HD Forwarders S·O·S Information
G3520C and G3520E Engines Camshaft
C9 Marine Generator Set Engines Lubrication System
Procedure to Modify the Engine Harness when Installing the 228-0267 Valve GP - Modulating or the 228-0266 Coil {3139} Procedure to Modify the Engine Harness when Installing the 228-0267 Valve GP - Modulating or the 228-0266 Coil {3139}
3500 Spark Ignited Engines Turbocharger
C9 Marine Generator Set Engines Electronic Unit Injector - Test