0043-02 Key Switch Fault (71)
产生此代码的情况:
发动机控制模块 (ECM) 检测出在 1 秒内钥匙开关至少循环了 3 次。
这表示在发动机运行期间,通向钥匙开关的蓄电池电路存在间歇性状况或蓄电池电量不足状态。
注: 快速循环钥匙开关即可产生该代码。 车上有些控制模块需要进行此操作,以便触发闪光代码。 如果这种情况发生了,应清除记录的诊断代码,以防将来引起混淆或得出不正确的诊断。
注: 此代码也可以因为在停机后立即尝试重新起动发动机而产生。 如果发动机转速在重新起动之前没有达到 0 rpm,发动机无法起动。
系统响应:
ECM 将记录诊断代码并触发快照。 该诊断代码为激活状态的同时,检查发动机指示灯亮起。 ECM 停止对喷油器电磁阀的通电。
发动机停机
测试步骤 1. 进行以下的诊断步骤: 点火钥匙开关电路和蓄电池供电电路 - 测试
结果:
- 正常 - 停止
Caterpillar Information System:
C9 On-highway Engines Fuel System - Prime
120H and 135H Motor Graders Seat Belt
C7 and C9 On-Highway Engines 0042-11 Injection Actuation Pressure output fault
3406E, C-10 and C-12 On-highway Engines 0121-05 Low/High Retarder current low (14)
3406E, C-10 and C-12 On-highway Engines 0121-06 Low/High Retarder current high (14)
3126B and 3126E On-highway Engines 0041-04 8 Volt Supply voltage low (21)
C9 Marine Engines and C9 Marine Generator Sets Housing (Front)
3126B and 3126E On-highway Engines 0041-03 8 Volt Supply voltage high (21)
G3520C and G3520E Engines Engine Design
C11 and C13 Engines Piston Cooling Jet
3406E, C-10 and C-12 On-highway Engines 0190-02 Primary Engine Speed Loss of Signal (34)
C7 and C9 On-Highway Engines 0190-11 Primary Engine Speed no pattern (34)
3406E, C-10 and C-12 On-highway Engines 0122-06 Med/High Retarder current high (14)
3406E, C-10 and C-12 On-highway Engines 0122-05 Med/High Retarder current low (14)
3406E, C-10 and C-12 On-highway Engines 0190-00 Engine Overspeed Warning (35)
G3520C and G3520E Generator Set Engines Engine Monitoring System
793B Off-Highway Truck Suspension Cylinder Suspension Cylinder (Front)
793B Off-Highway Truck Suspension Cylinder Suspension Cylinder (Rear)
3126B and 3126E On-highway Engines 0252-11 Engine Software Incorrect (59)
3406E, C12, C15 and C18 Marine Engines CID 0262 FMI 03 5 Volt Sensor DC Power Supply short to +batt
3406E, C12, C15 and C18 Marine Engines CID 0262 FMI 04 5 Volt Sensor DC Power Supply short to ground
C7 Engines for Combat and Tactical Vehicles 0253-02 Check Customer or System Parameters (56)
2002/11/01 Correction to Special Instruction , "Additional Information for the Customer Communication Module (CCM) that Is Used on Series 3500 and 3600 Gas Applications" {1926}
3054E Industrial Engine Glow Plugs - Test