Refill Capacities
The capacity of the lubrication system includes the capacity of the oil filters that are installed at the factory.
For the recommended oil, see this Operation and Maintenance Manual, "Engine Oil" topic (Maintenance Section).
Show/hide table
| Approximate Refill Capacity for the 3512B Engine Lubrication System | ||
|---|---|---|
| Compartment or System | Liters | US Gallons |
| Engine crankcase | |
110 US gal |
To properly maintain the cooling system, the total capacity of the cooling system must be determined. The capacity of the total cooling system will vary between individual installations. The external system includes the heat exchanger and piping. Refer to the specifications that are provided by the OEM of the vessel. Record the total cooling system capacity in the following Table.
For the recommended coolant, see this Operation and Maintenance Manual, "Coolant Recommendations" (Maintenance Section).
Show/hide table
| Approximate Refill Capacity for the 3512B Engine Cooling System | ||
|---|---|---|
| Compartment or System | Liters | US Gallons |
| Jacket water system | 134.2 L | 35.4 US gal |
Caterpillar Information System:
539 Knuckleboom Loader Receiver Dryer (Refrigerant) - Replace
C7 and C9 On-Highway Engines 0105-00 High Intake Manifold Air Temperature Warning (64)
3512B Marine Auxiliary Engine Air Starting System Operation
C7 and C9 On-Highway Engines 0102-07 Boost Pressure not responding
C7 and C9 On-Highway Engines 0100-11 Very Low Oil Pressure (46)
2007/07/02 A New Ignition Transformer Group And A New Spark Plug Are Used {1550, 1555, 1561}
C11 and C13 Engines Turbocharger
C11, C13 and C15 On-highway Engines Injector Solenoid Circuit - Test
2002/10/01 The Procedure For Tightening The Clamping Bolt For The Unit Injector Has Changed {1250, 1290}
2002/11/01 The Procedure For Tightening The Clamping Bolt For The Unit Injector Has Changed {1250, 1290}
2002/10/21 The Procedure For Tightening The Clamping Bolt For The Unit Injector Has Changed {1250, 1290}
3618 Engine Flywheel and Ring Gear - Remove and Install
3512B Marine Auxiliary Engine Fumes Disposal System
C7 and C9 On-Highway Engines 0105-11 Very High Intake Manifold Air Temperature (64)
3406E, C-10 and C-12 On-highway Engines 0108-03 Barometric Pressure voltage high (26)
3406E, C-10 and C-12 On-highway Engines 0108-04 Barometric Pressure voltage low (26)
C7 and C9 On-Highway Engines 0110-00 High Coolant Temperature Warning (61)
C11, C13 and C15 On-highway Engines Engine Pressure Sensor Open or Short Circuit - Test
C7 and C9 On-Highway Engines 0110-03 Coolant Temperature voltage high (27)
C11, C13 and C15 On-highway Engines 5 Volt Engine Pressure Sensor Supply Circuit - Test
3512B Marine Auxiliary Engine Black Start System
3516B Generator Set Engines with Dynamic Gas Blending Grounding Practices
C7 and C9 On-Highway Engines 0110-04 Coolant Temperature voltage low (27)
3512B Marine Auxiliary Engine Engine Design