A New Warning Film Is Now Available for the Material Handling Arms {6542, 7405} Caterpillar

Work Tool

MH ARM (S/N: Z2E1-UP; Z2F1-UP)

Reference: Refer to Operation and Maintenance Manual , SEBU8470 , "Fusion Material Handling Arm".

A new warning film is now available for the material handling arms listed below. The new film is provided to warn the operator of potential hazard of the tube falling out of the frame assembly.

Install film (1) to the left-hand side of any older material handling arms in the field that do not have the film. Apply the film as near to the end of the frame assembly as possible as shown in Illustration 1. The material handling arm groups are listed in Table 1.

Illustration 1	g06209268
Typical example Material handling arm (1) 518-3003 Film

Note: When adjusting the tube length, position the material handling arm approximately 203.2 mm (8.0 inch) to 304.8 mm (12.0 inch) off the ground before removing the pin and extending the tube assembly to the desired position.