3126E and 3126B Commercial and Truck Engines Caterpillar


Customer Specified Parameters

Usage:

3126B 1AJ
使用以下表格记录编程设置的规格。

识别参数

  • "额定值号(Rating Number)"____________________

  • "额定值选择(Rating Selection)" (A-E)____________________

  • "发动机序列号(Engine Serial Number)"____________________

  • "功率额定值(马力@转速)"____________________

  • "车辆识别号(Vehicle ID)"____________________

"卡车制造厂参数(Truck Manufacturer Parameters)"

  • "卡车制造厂(Truck Manufacturer)"____________________

车速参数(Vehicle Speed Parameters)

  • "车速标定(Vehicle Speed Calibration)"____________________ 脉冲数/ km (mile)____________________

  • "车速标定(Vehicle Speed Calibration) (J1939-Trans)"____________________

  • "车速标定(Vehicle Speed Calibration) (J1939-ABS)"____________________

  • "车速限制(Vehicle Speed Limit)"____________________ km/h (mph)

  • "车速限制保护(VSL Protection)"____________________

  • "转速表标定(Tachometer Calibration)"____________________脉冲数/转

  • "柔性车速限制(Soft Vehicle Speed Limit)"____________________

  • "低速范围驱动桥传动比(Low Speed Range Axle Ratio)"____________________

  • "高速范围驱动桥传动比(High Low Speed Range Axle Ratio)"____________________

巡航控制参数(Cruise Control Parameters)

  • "巡航控制车速设置下限(Low Cruise Control Speed Set Limit)"____________________ km/h (mph)

  • "巡航控制车速设置上限(High Cruise Control Speed Set Limit)"____________________ km/h (mph)

  • "发动机制动(Engine Brake)"____________________

  • "巡航/怠速/动力输出开关配置(Cruise/Idle/PTO Switch Configuration)"____________________

  • "柔性巡航控制(Soft Cruise Control)"____________________

怠速参数(Idle Parameters)

  • "怠速车速限制(Idle Vehicle Speed Limit)"____________________ km/h (mph)

  • "怠速转速限制(Idle RPM Limit)" ____________________

  • "怠速/动力输出发动机转速爬升速率(Idle/PTO Engine Speed Ramp Rate)" ____________________ 转/秒

  • "怠速/动力输出突变转速(Idle/PTO Bump RPM)" ____________________

  • "快怠速转速#1(Fast Idle RPM #1)"____________________

  • "快怠速转速#2(Fast Idle RPM #2"____________________

  • "暖机模式下的怠速转速(Idle Speed for Warm Up Mode)"____________________

动力输出专用参数(Dedicated PTO Parameters)

  • "动力输出配置(PTO Configuration)" ____________________

  • "动力输出发动机转速上限(PTO Top Engine Limit)" ____________________

  • "动力输出发动机设置转速(PTO Engine RPM Set Speed)" ____________________

  • "动力输出发动机设置转速 A(PTO Engine RPM Set Speed A)" ____________________

  • "动力输出发动机设置转速 B(PTO Engine RPM Set Speed B)" ____________________

  • "动力输出受到转速(PTO to Set Speed)" ____________________

  • "最高动力输出允许操作转速(Maximum PTO Enable Speed)"____________________

  • "动力输出驾驶室油门转速限制(PTO Cab Throttle RPM Limit)" ____________________

  • "动力输出车速限制(PTO Vehicle Speed Limit)" ____________________

  • "扭矩限制(Torque Limit)" ____________________ N·m (lb ft)

  • "动力输出停机时间(PTO Shutdown Time)" ____________________

  • "动力输出冷却风扇(如有配备)的启动(PTO Activation of Cooling Fan)" ____________________

发动机/挡位参数(Engine/Gear Parameters)

  • "较低挡位发动机转速限制(Lower Gears Engine RPM Limit)" ____________________

  • "较低挡位停用车速(Lower Gears Turn Off Speed)" ____________________ km/h (mph)

  • "中间挡位发动机转速限制(Intermediate Gears Engine RPM Limit)" ____________________

  • "中间挡位停用车速(Intermediate Gears Turn Off Speed)" ____________________ km/h (mph)

  • "减挡保护发动机转速限制(Gear Down Protection RPM Limit)" ____________________

  • "减挡保护启用车速(Gear Down Protection Turn On Speed)" ____________________ km/h (mph)

  • "发动机低怠速转速(Low Idle Engine RPM)"____________________

  • "怠速质量标定(Idle Quality Calibration)" ____________________

  • "变速器类型(如有配备)(Transmission Style)" ____________________

  • "AT/MT/HT部分油门换挡车速(AT/MT/HT Part Throttle Shift Speed)"____________________

  • "起动辅助输出模式(Starting Aid Output Mode)"____________________

  • "调速器型号"____________________

定时器参数(Timer Parameters)

  • "怠速停机时间(Idle Shutdown Time)" ____________________

  • "允许怠速停机超越( Allow Idle Shutdown Override)" ____________________

  • "空调压力开关(如有配备)风扇接通时间(A/C Pressure Switch Fan On-Time)" ____________________

  • "发动机制动(如有配备)启用时风扇完全接通时间(Fan with Engine Brake On-Full)" ____________________

  • "排气制动/暖机模式允许操作(Exhaust Brake/Warm up Enable)"____________________

智能怠速参数(Smart Idle Parameters)

  • "蓄电池监测和发动机控制电压(Battery Monitor and Engine Control Voltage)"____________________

  • "蓄电池监测和发动机低怠速转速(Battery Monitor and Low Idle Engine Speed)"____________________

发动机监测参数(Engine Monitoring Parameters)

  • "发动机监测模式(Engine Monitoring Mode)" ____________________告警(Warning), 告警/减额(Warning/Derate), 告警/减额/停机(Warning/Derate/Shutdown) 和 冷却液油位传感器(如有配备)允许操作/禁止操作(Coolant Level Sensor Enable/Disable)

  • "发动机监测灯(Engine Monitoring Lamps) (如有配备)" ____________________

  • "冷却液液位传感器"____________________

  • "发动机机油压力传感器" ____________________

  • "机油油位开关(Oil Level Switch) (如有配备)" ____________________

保养参数(Maintenance Parameters)

  • "保养指示器模式(Maintenance Indicator Mode)"____________________手动-小时数(Manual-Hours), 自动-小时数(Auto-Hours), 手动-耗油量(Manual-Fuel) 和 自动-耗油量(Auto-Fuel)

  • "预防性保养1 周期(PM1 Interval)"____________________

  • "发动机机油容量" ____________________

燃油箱参数(Fuel Tank Parameters)

  • "主燃油箱容量(Primary Fuel Tank Capacity) (如有配备)"____________________

  • "第二燃油箱容量(Secondary Fuel Tank Capacity) (如有配备)"____________________

行驶参数(Trip Parameters)

  • "仪表板预防性保养1 复位(Dash-PM1 Reset)" ____________________

  • "仪表板-用户参数(Dash-Customer Parameters)" ____________________防盗系统控制(Theft Deterrent System Control) 和 急停发生率(Quick-Stop Rate)

输入选择(Input Selections)

  • "风扇超越开关(Fan Override Switch)"____________________

  • "变速器空挡开关(Transmission Neutral Switch)"____________________

  • "排气制动开关(Exhaust Brake Switch)"____________________

  • "忽略制动/离合器开关(Ignore Brake/Clutch Switch)"____________________

  • "双速驱动桥开关(Two Speed Axle Switch)"____________________

  • "车速输入(Vehicle Speed Input)"____________________

  • "动力输出发动机停机开关(PTO Engine Shutdown Switch)"____________________

  • "扭矩限制开关"____________________

  • "动力输出发动机转速设置输入A(PTO Engine RPM Set Speed Input A)"____________________

  • "动力输出发动机转速设置输入B(PTO Engine RPM Set Speed Input B)"____________________

  • "诊断允许操作开关(Diagnostic Enable Switch)"____________________

  • "巡航控制通断开关(Cruise Control ON/Off Switch)"____________________

  • "巡航控制设置/恢复 /加速/减速开关(Cruise Control Set/Resume /Accel/Decel Switch)"____________________

  • "巡航控制暂停开关(Cruise Control Pause Switch)"____________________

  • "离合器踏板位置开关(Clutch Pedal Position Switch)"____________________

  • "行车制动踏板开关#1(Service Brake Pedal Position Switch #1)"____________________

输出选择(Output Selections)

  • "风扇控制型式(Fan Control Type) (如有配备)" ____________________

  • "动力输出活动输出(PTO Active Output)"____________________

  • "动力输出开关接通指示灯(PTO Switch ON Lamp)"____________________

  • "快怠速允许操作指示灯(Fast Idle Enabled Lamp)"____________________

  • "换油指示灯(Change Oil Lamp)"____________________

  • "发动机正在运转输出(Engine Running Output)"____________________

  • "起动辅助输出(Starting Aid Output)"____________________

数据链路参数(Data Link Parameters)

  • "动力系数据链路(Powertrain Data Link)" ____________________

Caterpillar Information System:

C12 Marine Engines Model View Illustrations
3408E and 3412E Industrial Engines Water Temperature Indicator
3054 and 3056 Engines 550 Generator Set Control Panel Symbols
3054 and 3056 Engines 550 Generator Set Control Panel Input/Output Expansion
3054 and 3056 Engines 550 Generator Set Control Panel Keys
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply Firmware - Update
3056E Industrial Engine Engine Valve Lash - Inspect/Adjust
C12 Marine Engine Lubrication System
3408E and 3412E Industrial Engines Maintenance Interval Schedule - 3412E Industrial Engine
3408E and 3412E Industrial Engines Maintenance Interval Schedule - 3408E Industrial Engine
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply Firmware Compatibility
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Final Drive - Install
3408E and 3412E Industrial Engines Stopping the Engine
CIPI UNDERCARRIAGE Arrangements: 9Q-5195, 9Q-5197, 9Q-5198, 9Q-5232, 9Q-5504, 9Q-5643, 9Q-5651, 9Q-5727, 9Q-5728, 9Q-5729, 9Q-5730, 9Q-5731, 9Q-5747, 9Q-5876, 180-4029, and 213-3892 Part Number Location
3408E and 3412E Industrial Engines Gauges and Indicators
3054 and 3056 Engines 550 Generator Set Control Panel Service Tools
3408E and 3412E Industrial Engines Air Starting System
3126E and 3126B Commercial and Truck Engines Starting the Engine
3408E and 3412E Industrial Engines Electrical System
3054 and 3056 Marine Generator Set Engines Turbocharger - Remove - 3056 Engine
3500B Locomotive Engines Diagnostic Codes
3054 and 3056 Marine Generator Set Engines Exhaust Manifold - Remove and Install - 3056 Engine
3054 and 3056 Marine Generator Set Engines Exhaust Manifold - Remove and Install - 3054 Engine
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Refill Capacities
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.