- Excavator:
- 320C (S/N: ANB1-UP; AMC1-UP)
- Work Tool:
- COUPLER (S/N: 7SW1-UP)
Introduction
This special instruction covers the installation procedure for 194-0562 Lines Support Gp .
Safety Section
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
 |
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
 |
|
Personal injury or death can result from improperly checking for a leak. Always use a board or cardboard when checking for a leak. Escaping air or fluid under pressure, even a pin-hole size leak, can penetrate body tissue causing serious injury, and possible death. If fluid is injected into your skin, it must be treated immediately by a doctor familiar with this type of injury. |
|
Required Parts
| 194-0562 Lines Support Gp Revision -00 | |||
|---|---|---|---|
| Item | Qty | Part No | Description |
| (1) | 1 | 194-0566 | Plate |
| (2) | 2 | 194-0568 | Plate As |
| (3) | 2 | 6V-9172 | Nut |
| (4) | 2 | 7X-2464 | Union |
| (5) | 4 | 8T-4184 | Bolt |
| (6) | 12 | 8T-4223 | Hard Washer |
| (7) | 4 | 8T-4244 | Nut |
| (8) | 4 | 8T-4956 | Bolt |
 | |
| Illustration 1 | g03739081 |
194-0562 Lines Support Gp | |
Installation Procedure
 | |
| Illustration 2 | g00104545 |
Prevent the machine from movement. Park the machine on a level surface.
Attach a "Do Not Operate" warning tag or a similar warning tag to the start switch or to the controls before you service the equipment. These warning tags (Special Instruction, SEHS7332) are available from your Caterpillar dealer.
- Install plate assemblies (2) .
 | |
| Illustration 3 | g03739084 |
(1) 194-0566 Plate (2) 194-0568 Plate As (3) 6V-9172 Nut (4) 7X-2464 Union (5) 8T-4184 Bolt (6) 8T-4223 Hard Washer (7) 8T-4244 Nut (8) 8T-4956 Bolt | |
- Attach plate (1) to plate assemblies (2) .
- Install hardware onto plate assemblies.