Camshaft - Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
B | 8T-2998 | Lubricant | 1 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Do not use a torch to heat camshaft gear (7). Raise the temperature of camshaft gear (7).
Note: The key for camshaft gear (7) must be in position on the camshaft before camshaft gear (7) is installed.
- Apply Tooling (B) to the camshaft lobes and the rollers for the valve lifter. Apply clean engine oil to the bearing journals of the camshaft.
Show/hide table
Illustration 2 g00572105 - Install camshaft (6) until the rear of the camshaft is even with the rear of the cylinder block.
Show/hide table
Illustration 3 g00572090 - Align Marks “V” on the camshaft gear and the idler gear.
Show/hide table
Illustration 4 g00572095 - Install plate (4) and bolts (5) on the cylinder block.
Show/hide table
Illustration 5 g00572086 - Install gear (3), plate (2), and bolts (1) on the rear of the camshaft.
Show/hide table
Illustration 1 | g00572214 |
End By:
- Install the flywheel housing. Refer to Disassembly and Assembly, "Flywheel Housing - Remove and Install".
- Install the lifter group. Refer to Disassembly and Assembly, "Lifter Group - Remove and Install".
- Install the front housing. Refer to Disassembly and Assembly, "Housing (Front) - Install".
Caterpillar Information System:
3412E, C30 and C32 Marine Engines Camshaft - Remove
3126B Engines for Caterpillar Built Machines Fuel Transfer Pump - Remove - If Equipped
3126B Engines for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install
3412C Engine Pistons and Connecting Rods - Disassemble
SPS342 Skid Mounted Pumper Plate Locations and Film Locations
3412C Engine Crankshaft - Install
Product Identification Numbers (PIN) Location Guide Types of Labels and Plates
Product Identification Numbers (PIN) Location Guide Types of Identification Numbers
Product Identification Numbers (PIN) Location Guide General Information
G3408C and G3412C Engines Air Cleaner Housing - Remove and Install
C9 Marine Engines and C9 Marine Generator Sets Cylinder Liner - Install
3054 and 3056 Industrial and Generator Set Engines Overhaul Considerations
3500B Engines Turbocharger
3126B Engines for Caterpillar Built Machines Fuel Transfer Pump - Install - If Equipped
3412C Engine Pistons and Connecting Rods - Assemble
G3500 Generator Sets Refill Capacities
G3408C and G3412C Engines Turbocharger - Disassemble
SPS342 Skid Mounted Pumper Model View Illustrations
Product Identification Numbers (PIN) Location Guide Excavator (Track)
G3408C and G3412C Engines Turbocharger - Assemble
Product Identification Numbers (PIN) Location Guide Track-Type Tractor
3412C Engine Connecting Rod
2001/04/16 Correction to Operation and Maintenance Manual, SEBU7275-01, "Maintenance Interval Schedule" {7500}
G3408C and G3412C Engines Water Temperature Regulator - Remove