Event Codes
Show/hide table
事件代码     | |
---|---|
EID     | 代码描述     |
004     | 发动机超速停机     |
005     | 燃油滤清器阻塞减额     |
006     | 燃油滤清器阻塞停机     |
015     | 发动机冷却液温度过高降低额定功率     |
016     | 发动机冷却液温度过高停机     |
017     | 发动机冷却液温度过高警告     |
025     | 进气温度高减额     |
027     | 进气温度过高警告     |
039     | 发动机机油压力低降低额定功率     |
040     | 发动机机油压力过低停机     |
054     | 燃油温度过高降低额定功率     |
055     | 燃油温度过高停机     |
056     | 燃油温度过高警告     |
057     | 发动机冷却液液位低降低额定功率     |
058     | 发动机冷却液液位低停机     |
059     | 发动机冷却液液位低警告     |
095     | 燃油滤清器堵塞警告     |
096     | 燃油压力过高     |
100     | 发动机机油压力过低警告     |
190     | 发动机超速警告     |
443     | 辅助压力偏高     |
445     | 辅助温度偏高     |
电子控制模块(ECM)可记录事件。 事件指发动机的工作状况,象机油压力低或冷却液温度高。 记录事件通常指示机械问题而不是电子系统问题。
Show/hide table
图 1 | g00740986 |
典型模拟温度传感器的输出电压 (显示的冷却液温度传感器) |
可编程设定的监控系统参数
可在工业用发动机监控系统内选择以下特性。
- 警告
- 减额
- 停机
Caterpillar 电子技师(ET)可用于选择监控特性。 可以接通或断开这些特性。 事件激活时,ECM 将会产生事件代码。
ECM 将在 Cat 数据链路上产生 EID 诊断代码。 此诊断代码将显示在 Cat 电子技师的诊断屏幕上。
ECM 将在 J1939 数据链路上产生 SPN-FMI 诊断代码。 此诊断代码可能显示在 J1939 数据链路的接收装置上。
ECM 将会产生通过诊断灯显示的闪存代码。
警告灯将会显示下列情况。
- 出现"警告"时持续点亮。
- 出现"减额"时闪烁。
断开选择的某一级别时,ECM 将会记录事件代码,但不会对该事件采取任何行动。 例如,ECM 将不会采取警告、减额或停机行动。
如果有多个减额为激活状态,所显示的减额将会是限制发动机功率最多的减额。
Caterpillar Information System:
3126B Industrial Engines CID 0274 FMI 04 Atmospheric Pressure short to ground
3126B Industrial Engines CID 0274 FMI 03 Atmospheric Pressure open/short to +batt
3126B Industrial Engines CID 0273 FMI 04 Turbo Outlet Pressure short to ground
3126B Industrial Engines CID 0273 FMI 03 Turbo Outlet Pressure open/short to +batt
3126B Industrial Engines CID 0262 FMI 04 5 Volt Sensor DC Power Supply short to ground
3126B Industrial Engines CID 0262 FMI 03 5 Volt Sensor DC Power Supply short to +batt
3054 and 3056 Marine Generator Set Engines Crankshaft Gear - Remove and Install
3054 and 3056 Marine Generator Set Engines Lifter Group - Remove and Install
C-9 Industrial Engine CID 0110 FMI 04 Engine Coolant Temperature short to ground
2000/12/01 Change of Mounting Location for the Middle Vibration Isolator on All 3508 Generator Set Packages {1021}
C-9 Industrial Engine CID 0110 FMI 03 Engine Coolant Temperature open/short to +batt
3054 and 3056 Marine Generator Set Engines Crankshaft Front Seal - Install
C-10, C-12, C-15 and C-16 Industrial Engines E017 High Engine Coolant Temperature Warning
2001/01/01 New Engine Pressure Sensors are Available {1917, 1923, 1925}
3054, 3054B and 3056 Marine Engines Emissions Certification Film
Marine Monitoring System II Resistance Temperature Detector Module
3054, 3054B and 3056 Marine Engines Fuel Filter Base
C-9 Engines for Caterpillar Built Machines Piston Ring Groove - Inspect
C-9 Engines for Caterpillar Built Machines Alternator - Test
3054, 3054B and 3056 Marine Engines Control Panel
3054, 3054B and 3056 Marine Engines Engine Oil Cooler
Marine Monitoring System II Input Module and Output Module - Replace
3054 and 3056 Industrial and Generator Set Engines Alternator Mounting
2000/12/01 Marine Power Display is Available {7490}