Engine Oil Cooler
3054 and 3054B Engine
Show/hide table
Illustration 1 | g00790530 |
(1) Tighten the adapter for the engine oil filter to the following torque. ... 37 N·m (27 lb ft)
(2) Engine oil cooler
- The bypass valve in the oil cooler opens at the following pressure, if equipped. ... 172 kPa (25 psi)
(3) Engine oil filter base
(4) Bolt
3056 Engine
Show/hide table
Illustration 2 | g00755381 |
(1) Engine oil cooler core
Note: The baffle on the engine oil cooler core must face the front of the engine.
(2) Stud
Apply 4C-4030 Thread Lock Compound to the first three threads of the studs in the cylinder block.
(3) Bolt
- Tighten the bolts that fasten the oil cooler cover to the cylinder block to the following torque. ... 22 N·m (16 lb ft)
(4) Flange for the oil cooler lines
(5) Nut
- Tighten the nuts that fasten the oil cooler lines to the engine oil cooler to the following torque. ... 22 N·m (16 lb ft)
(6) Nut
- Tighten the nuts that fasten the oil cooler cover to the cylinder block to the following torque. ... 22 N·m (16 lb ft)
(7) Cover
Apply 3S-6252 Sealant to the mating surfaces of cover (7) and the cylinder block before installation.
(8) O-ring seals
Install new O-ring seals on the flanges of the engine oil cooler core.
Caterpillar Information System:
3054, 3054B and 3056 Marine Engines Control Panel
C-9 Engines for Caterpillar Built Machines Alternator - Test
C-9 Engines for Caterpillar Built Machines Piston Ring Groove - Inspect
3054, 3054B and 3056 Marine Engines Fuel Filter Base
Marine Monitoring System II Resistance Temperature Detector Module
3054, 3054B and 3056 Marine Engines Emissions Certification Film
2001/01/01 New Engine Pressure Sensors are Available {1917, 1923, 1925}
C-10, C-12, C-15 and C-16 Industrial Engines E017 High Engine Coolant Temperature Warning
C-10, C-12, C-15 and C-16 Industrial Engines Event Codes
3126B Industrial Engines CID 0274 FMI 04 Atmospheric Pressure short to ground
3126B Industrial Engines CID 0274 FMI 03 Atmospheric Pressure open/short to +batt
3126B Industrial Engines CID 0273 FMI 04 Turbo Outlet Pressure short to ground
Marine Monitoring System II Input Module and Output Module - Replace
3054 and 3056 Industrial and Generator Set Engines Alternator Mounting
2000/12/01 Marine Power Display is Available {7490}
2000/11/01 Revised Coolant Recommendations For Gas Engines {1350, 1352, 1395}
3054 and 3056 Marine Generator Sets Alarm Switches
3054, 3054B and 3056 Marine Engines Stopping the Engine
C-10, C-12, C-15 and C-16 Industrial Engines System Configuration Parameters
3054, 3054B and 3056 Marine Engines Manual Stop Procedure
3456 Engine, 836G Landfill Compactor, 834G Wheel Dozer and 988G Wheel Loader Flash Programming
3054, 3054B and 3056 Marine Engines Emergency Procedures
2001/07/01 New Tightening Procedure for Connecting Rod Bolts in 3600, G3600, and C280 Engines {1218, 1225}
C9 Urban Transit Bus Engine Programming Parameters