CID 0274 FMI 03 Atmospheric Pressure open/short to +batt
产生此代码的情况:
电子控制模块(ECM)从大气压力传感器检测到高于4.8 伏(volts)的信号电压。
系统响应:
ECM会将大气压力设定为一个缺省值。 监测系统中的大气压力参数将会被停用。
无
测试步骤 1. 进行以下的诊断步骤: 模拟传感器开路或短路 - 测试
结果:
- 故障被排除 - 停止
Caterpillar Information System:
3126B Industrial Engines CID 0273 FMI 04 Turbo Outlet Pressure short to ground
3126B Industrial Engines CID 0273 FMI 03 Turbo Outlet Pressure open/short to +batt
3126B Industrial Engines CID 0262 FMI 04 5 Volt Sensor DC Power Supply short to ground
3126B Industrial Engines CID 0262 FMI 03 5 Volt Sensor DC Power Supply short to +batt
3054 and 3056 Marine Generator Set Engines Crankshaft Gear - Remove and Install
3054 and 3056 Marine Generator Set Engines Lifter Group - Remove and Install
C-9 Industrial Engine CID 0110 FMI 04 Engine Coolant Temperature short to ground
2000/12/01 Change of Mounting Location for the Middle Vibration Isolator on All 3508 Generator Set Packages {1021}
C-9 Industrial Engine CID 0110 FMI 03 Engine Coolant Temperature open/short to +batt
3054 and 3056 Marine Generator Set Engines Crankshaft Front Seal - Install
3054 and 3056 Marine Generator Set Engines Crankshaft Front Seal - Remove
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Generator Monitoring System Thermocouple Module
3126B Industrial Engines CID 0274 FMI 04 Atmospheric Pressure short to ground
C-10, C-12, C-15 and C-16 Industrial Engines Event Codes
C-10, C-12, C-15 and C-16 Industrial Engines E017 High Engine Coolant Temperature Warning
2001/01/01 New Engine Pressure Sensors are Available {1917, 1923, 1925}
3054, 3054B and 3056 Marine Engines Emissions Certification Film
Marine Monitoring System II Resistance Temperature Detector Module
3054, 3054B and 3056 Marine Engines Fuel Filter Base
C-9 Engines for Caterpillar Built Machines Piston Ring Groove - Inspect
C-9 Engines for Caterpillar Built Machines Alternator - Test
3054, 3054B and 3056 Marine Engines Control Panel
3054, 3054B and 3056 Marine Engines Engine Oil Cooler
Marine Monitoring System II Input Module and Output Module - Replace