Aftercooler - Disassemble
Disassembly Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Remove two bolts that hold flange (3) to inner housing (1). Remove O-ring seal (2) .
Show/hide table
 | |
| Illustration 1 | g00748551 |
- Remove two bolts that hold flange (7) to air intake housing (4). Remove O-ring seal (6) .
- Remove two bolts (5) from air intake housing (4) .
- Remove sixteen bolts (10) that fasten inner housing (1) to air intake housing (4). Remove the bolts in a sequence that starts at each end of the housing. Then, work toward the center of the housing.
Show/hide table
 | |
| Illustration 2 | g00748579 |
- Separate inner housing (1) and air intake housing (4). Slide air intake housing (4) away from line (9) for the sea water outlet. Remove the air intake housing.
- Carefully remove aftercooler (8) from inner housing (1) .
Caterpillar Information System:
3500B Industrial Engines Engine Sensor Open/Short Test
C9 Engine For Caterpillar Built Machines Cylinder Block Cover - Remove and Install
3054E and 3056E Industrial Engines Stopping the Engine
3126B and 3126E Truck Engines Engine Oil Temperature Sensor
G3408 and G3412 Engines Exhaust Manifold - Water Cooled
3608 Engine Specifications
3114, 3116, and 3126 Engines for Caterpillar Built Machines Fuel Transfer Pump - Remove
3114, 3116, and 3126 Engines for Caterpillar Built Machines Fuel Transfer Pump - Install
G3408 and G3412 Engines Cylinder Head
G3408C and G3412C Engines Cylinder Head
3126B Industrial Engine Alternator and Regulator
C9 Engines for Caterpillar Built Machines Crankcase Breather - Remove and Install
3608 Engine Tools
G3408 and G3412 Engines Valve Cover
320E and 323E Excavators VA Boom Controls - If Equipped
3054, 3054B and 3056 Marine Engines Aftercooler - Assemble
C9 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Disassemble
2001/06/01 A New Rubber Boot Is Available To Help Protect The Actuator Shafts In The Hydrax System {1716}
3126B Industrial Engine Reference Material
2001/01/01 New Spark Plugs Are Available {1555}
3500B Industrial Engines Aftercooler Coolant Temperature Sensor
3500B Industrial Engines Ether Injection System
3500 Generator Set Engines Water Connection Group
3500 Industrial Engines Air Compressor