 | |
| Illustration 1 | g00292354 |
 | |
| Illustration 2 | g00292355 |
Note: Load the battery with a carbon pile 4C-4911 Battery Load Tester in order to get the maximum alternator output.
9W-3034 Alternator
- Polarity ... Negative ground
- The rotation of the alternator is viewed from the pulley. ... Clockwise
The minimum full load current at 5000 rpm is the following value. ... 47 Amp
The minimum full load current at 1500 rpm is the following value. ... 13.5 Amp
Output voltage ... 28.0 ± 1.0 V
(1) Tighten the shaft nut to the following torque. ... 50 ± 5 N·m (37 ± 4 lb ft)
(2) Tighten the screw to the following torque. ... 3.6 ± 0.8 N·m (32 ± 7.0 lb in)
(3) Tighten the nut to the following torque. ... 7.75 ± 0.75 N·m (69± 6.0 lb in)
(4) Regulator
- Voltage setting ... No adjustment
- Permissible voltage range ... 27 to 29 V
107-7977 Alternator
- Polarity ... Negative ground
- Rotation of the alternator is viewed from the pulley. ... Clockwise
The minimum full load current at 5000 rpm is the following value. ... 68 Amp
The minimum full load current at 1500 rpm is the following value. ... 31 Amp
Output voltage ... 28.0 ± 1.0 V
(1) Tighten the shaft nut to the following torque. ... 102 ± 7 N·m (75 ± 5 lb ft)
(2) Tighten the screw to the following torque. ... 6.2 ± 0.6 N·m (55 ± 5 lb in)
(3) Tighten the nut to the following torque. ... 7.1 ± 0.9 N·m (63 ± 8 lb in)
(4) Regulator
- Voltage setting ... No adjustment
- Permissible voltage range ... 27 to 29 V
 | |
| Illustration 3 | g00758106 |
 | |
| Illustration 4 | g00757919 |
5N-5692 Alternator
- Polarity ... Negative ground
- Rotation of the alternator is viewed from the pulley. ... Clockwise
Note: This alternator can rotate clockwise or counterclockwise.
The minimum full load current at 5000 rpm is the following value. ... 42.3 Amp
The minimum full load current at 2000 rpm is the following value. ... 15.8 Amp
Note: Typically, low speed tests call for a minimum speed of 1500 rpm. The low speed test for this alternator is 2000 rpm.
Output voltage ... 28.0 ± 1.0 V
(1) Tighten the shaft nut to the following torque. ... 102 ± 7 N·m (75 ± 5 lb ft)
(2) Tighten the screw to the following torque. ... 2.2 ± .25 N·m (19.47 ± 2.21 lb in)
(3) Tighten the nut to the following torque. ... 6.2 ± .6 N·m (54.87 ± 5.31 lb in)
(4) Regulator
- Voltage setting ... No adjustment
- Permissible voltage range ... 27 to 29 V