Illustration 1 | g01394513 |
Typical example |
Illustration 2 | g01352989 |
Bolt tightening sequence for valve cover base |
Illustration 3 | g01413156 |
Bolt tightening sequence for the valve mechanism cover |
(1) Torque the bolts for the valve cover base in the numerical sequence that is shown in Illustration 2. ... 14 ± 4 N·m (125 ± 35 lb in)
(2) Torque the bolts for the valve mechanism cover in the numerical sequence that is shown in Illustration 3. ... 14 ± 4 N·m (125 ± 35 lb in)
(3) Cut the seal for the valve mechanism cover to the following length. ... 1409.7 ± 6.4 mm (55.50 ± 0.25 inch)
(4) Cut the seal for valve cover base to the following length. ... 1625.6 ± 6.4 mm (64.00 ± 0.25 inch)
(5) Before installation, coat both ends of the seals with black Loctite 593.
Illustration 4 | g01413358 |
Section A-A |
Use the following procedure to install the adapter (6) :
- Lubricate the bore lightly with clean engine oil.
- Lubricate the O-ring seal (7) lightly with clean engine oil.
- Freeze the adapter to at least -18 °C (-0 °F).
- Install the adapter.