Fuel Transfer Pump - Install
Installation Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 1U-6396     | O-Ring Assembly Compound     | 1     |
B     | 161-9203     | Grease Cartridge     | 1     |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Apply Tooling (A) to the O-ring seal.
- Use your finger to apply a small amount of Tooling (B) on the splines of the unit injector hydraulic pump. Only a small amount of grease is required to evenly coat the splines.
- Position fuel transfer pump (4) on the unit injector hydraulic pump and install bolts (3) . Tighten bolts (3) to a torque of 25 ± 3 N·m (18 ± 2 lb ft).
Show/hide table
Illustration 1 | g01025250 |
- Connect hose assembly (1) and hose assembly (2) .
Caterpillar Information System:
3126B Industrial Engine Fuel Transfer Pump - Remove
3500B Industrial Engines with the ADEM 3 Electronic Control Module Electronic Display Module - Optional
3406E Engine Engine Oil Filter Base - Assemble - Engine without BrakeSaver
Electronic Modular Control Panel II (EMCP II) Troubleshooting Diagnostic Codes
3406E Engine Engine Oil Filter Base - Disassemble - Engine without BrakeSaver
3054 and 3056 Marine Generator Set Engines Auxiliary Water Pump - Remove
C12 Marine Engines Closed Crankcase Ventilation (CCV) Filter Service Indicator - Inspect
3126 Truck Engine Military Rocker Shaft - Disassemble
3054, 3054B and 3056 Marine Engines Heat Exchanger - Install - 3056 Engine
3054, 3054B and 3056 Marine Engines Heat Exchanger - Assemble - 3056 Engine
G3500B Engines Engine Monitoring System
3054, 3054B and 3056 Marine Engines Heat Exchanger - Disassemble - 3056 Engine
3054 and 3056 Marine Generator Set Engines Auxiliary Water Pump - Install
3406E Engine Engine Oil Cooler - Remove
Electronic Modular Control Panel II (EMCP II) Starting Motor Magnetic Switch - Test - 3306B and 3406C MUI Engines
Electronic Modular Control Panel II (EMCP II) Starting Motor Magnetic Switch - Test - EUI Engines Only
Electronic Modular Control Panel II (EMCP II) Starting Motor Magnetic Switch - Test - 3412C, 3508, 3512, and 3516 MUI Engines Only
Electronic Modular Control Panel II (EMCP II) Pulse Width Modulated Sensor
2000/10/02 Harness Repair of Alternator R-Terminal Connector {1405, 1408, 7553}
3126 Truck Engine Military Rocker Shaft - Assemble
Electronic Modular Control Panel II (EMCP II) Block Diagram of Generator Set Control
Electronic Modular Control Panel II (EMCP II) Service Record
3406E Engine Engine Oil Cooler - Install
3054, 3054B and 3056 Marine Engines Marine Transmission Oil Cooler - Remove and Install - 3056 Engine