Engine Oil Filter Base - Assemble - Engine without BrakeSaver
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| |
| Illustration 1 | g01041064 |
Note: Check condition of O-ring seals (2). If the seals are damaged or worn, use new parts for replacement.
- Install valves (3) and (4) in engine oil filter base (1).
- Install springs (5) and (6) in the engine oil filter base.
Show/hide table
Improper assembly of parts that are spring loaded can cause bodily injury.
To prevent possible injury, follow the established assembly procedure and wear protective equipment.
- Install covers (7) on engine oil filter base (1).
End By:
- Install the engine oil filter base. Refer to Disassembly and Assembly, "Engine Oil Filter Base - Install".
Caterpillar Information System:
Electronic Modular Control Panel II (EMCP II) Troubleshooting Diagnostic Codes
3406E Engine Engine Oil Filter Base - Disassemble - Engine without BrakeSaver
3054 and 3056 Marine Generator Set Engines Auxiliary Water Pump - Remove
C12 Marine Engines Closed Crankcase Ventilation (CCV) Filter Service Indicator - Inspect
3126 Truck Engine Military Rocker Shaft - Disassemble
3054, 3054B and 3056 Marine Engines Heat Exchanger - Install - 3056 Engine
3054, 3054B and 3056 Marine Engines Heat Exchanger - Assemble - 3056 Engine
G3500B Engines Engine Monitoring System
3054, 3054B and 3056 Marine Engines Heat Exchanger - Disassemble - 3056 Engine
Electronic Modular Control Panel II (EMCP II) Schematics and Wiring Diagrams
3114, 3116, and 3126 Engines for Caterpillar Built Machines Governor - Remove
G3406 Engines Gear Group (Front)
3500B Industrial Engines with the ADEM 3 Electronic Control Module Electronic Display Module - Optional
3126B Industrial Engine Fuel Transfer Pump - Remove
3126B Industrial Engine Fuel Transfer Pump - Install
3054 and 3056 Marine Generator Set Engines Auxiliary Water Pump - Install
3406E Engine Engine Oil Cooler - Remove
Electronic Modular Control Panel II (EMCP II) Starting Motor Magnetic Switch - Test - 3306B and 3406C MUI Engines
Electronic Modular Control Panel II (EMCP II) Starting Motor Magnetic Switch - Test - EUI Engines Only
Electronic Modular Control Panel II (EMCP II) Starting Motor Magnetic Switch - Test - 3412C, 3508, 3512, and 3516 MUI Engines Only
Electronic Modular Control Panel II (EMCP II) Pulse Width Modulated Sensor
2000/10/02 Harness Repair of Alternator R-Terminal Connector {1405, 1408, 7553}
3126 Truck Engine Military Rocker Shaft - Assemble
Electronic Modular Control Panel II (EMCP II) Block Diagram of Generator Set Control