Heat Exchanger - Disassemble - 3056 Engine
Disassembly Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Put a mark (1) on end cap (3) and on the body of the heat exchanger. The mark will identify the proper position of the end cap for reassembly.
Show/hide table
Illustration 1 | g00744051 |
- Remove six bolts (2) from end cap (3) .
- Remove end cap (3) from the heat exchanger.
- Repeat Steps 1 through 3 in order to remove the end cap on the reverse end.
- Remove tube bundle (5) from the body of heat exchanger (4) .
Show/hide table
Illustration 2 | g00744076 |
- Discard the O-ring seals from both end caps.
Caterpillar Information System:
Electronic Modular Control Panel II (EMCP II) Schematics and Wiring Diagrams
3114, 3116, and 3126 Engines for Caterpillar Built Machines Governor - Remove
G3406 Engines Gear Group (Front)
3114, 3116, and 3126 Engines for Caterpillar Built Machines Governor - Install
G3406 Engines Cylinder Block
C7 Marine Engine Closed Crankcase Ventilation (CCV) Fumes Disposal Filter - Replace
3176C and 3196 Marine Engines Marine Power Display
G3406 Engine Turbocharger - Inspect
3054, 3054B and 3056 Marine Engines Heat Exchanger - Remove - 3056 Engine
3500B Engines and 776D, 777D, 784C, 785C, 789C, 793C and 793D Off-Highway Truck/Tractors Exhaust Manifold
PM3412C Power Modules Maintenance Interval Schedule
PM3412C Power Modules Refill Capacities
G3500B Engines Engine Monitoring System
3054, 3054B and 3056 Marine Engines Heat Exchanger - Assemble - 3056 Engine
3054, 3054B and 3056 Marine Engines Heat Exchanger - Install - 3056 Engine
3126 Truck Engine Military Rocker Shaft - Disassemble
C12 Marine Engines Closed Crankcase Ventilation (CCV) Filter Service Indicator - Inspect
3054 and 3056 Marine Generator Set Engines Auxiliary Water Pump - Remove
3406E Engine Engine Oil Filter Base - Disassemble - Engine without BrakeSaver
Electronic Modular Control Panel II (EMCP II) Troubleshooting Diagnostic Codes
3406E Engine Engine Oil Filter Base - Assemble - Engine without BrakeSaver
3500B Industrial Engines with the ADEM 3 Electronic Control Module Electronic Display Module - Optional
3126B Industrial Engine Fuel Transfer Pump - Remove
3126B Industrial Engine Fuel Transfer Pump - Install