Fuel Transfer Pump - Remove
Removal Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Disconnect hose assembly (1) and hose assembly (2). Immediately cap all openings or plug all openings in order to prevent contamination.
Show/hide table
 | |
| Illustration 1 | g01025250 |
- Remove bolts (3) .
- Remove fuel transfer pump (4) .
Caterpillar Information System:
3500B Industrial Engines with the ADEM 3 Electronic Control Module Electronic Display Module - Optional
3406E Engine Engine Oil Filter Base - Assemble - Engine without BrakeSaver
Electronic Modular Control Panel II (EMCP II) Troubleshooting Diagnostic Codes
3406E Engine Engine Oil Filter Base - Disassemble - Engine without BrakeSaver
3054 and 3056 Marine Generator Set Engines Auxiliary Water Pump - Remove
C12 Marine Engines Closed Crankcase Ventilation (CCV) Filter Service Indicator - Inspect
3126 Truck Engine Military Rocker Shaft - Disassemble
3054, 3054B and 3056 Marine Engines Heat Exchanger - Install - 3056 Engine
3054, 3054B and 3056 Marine Engines Heat Exchanger - Assemble - 3056 Engine
G3500B Engines Engine Monitoring System
3054, 3054B and 3056 Marine Engines Heat Exchanger - Disassemble - 3056 Engine
Electronic Modular Control Panel II (EMCP II) Schematics and Wiring Diagrams
3126B Industrial Engine Fuel Transfer Pump - Install
3054 and 3056 Marine Generator Set Engines Auxiliary Water Pump - Install
3406E Engine Engine Oil Cooler - Remove
Electronic Modular Control Panel II (EMCP II) Starting Motor Magnetic Switch - Test - 3306B and 3406C MUI Engines
Electronic Modular Control Panel II (EMCP II) Starting Motor Magnetic Switch - Test - EUI Engines Only
Electronic Modular Control Panel II (EMCP II) Starting Motor Magnetic Switch - Test - 3412C, 3508, 3512, and 3516 MUI Engines Only
Electronic Modular Control Panel II (EMCP II) Pulse Width Modulated Sensor
2000/10/02 Harness Repair of Alternator R-Terminal Connector {1405, 1408, 7553}
3126 Truck Engine Military Rocker Shaft - Assemble
Electronic Modular Control Panel II (EMCP II) Block Diagram of Generator Set Control
Electronic Modular Control Panel II (EMCP II) Service Record
3406E Engine Engine Oil Cooler - Install