Engine Oil Cooler - Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Clean tubes (8) for the oil cooler core with a rod that has a diameter of
3.81 mm (0.150 inch) .Show/hide tableIllustration 2 g01038823 - Attach a suitable lifting device to engine oil cooler (3). The weight of the oil cooler assembly is approximately
36 kg (80 lb) . Position engine oil cooler (3) on the engine. - Install bolts (4) that hold oil cooler bonnet (5) to engine oil cooler (3). Install oil cooler bonnet (2). Install bolts (1) that hold oil cooler bonnet (2) to engine oil cooler (3).
- Connect tube assemblies (6) and (7).
Show/hide table
Illustration 1 | g01039340 |
Caterpillar Information System:
Electronic Modular Control Panel II (EMCP II) Service Record
Electronic Modular Control Panel II (EMCP II) Block Diagram of Generator Set Control
3126 Truck Engine Military Rocker Shaft - Assemble
2000/10/02 Harness Repair of Alternator R-Terminal Connector {1405, 1408, 7553}
Electronic Modular Control Panel II (EMCP II) Pulse Width Modulated Sensor
Electronic Modular Control Panel II (EMCP II) Starting Motor Magnetic Switch - Test - 3412C, 3508, 3512, and 3516 MUI Engines Only
Electronic Modular Control Panel II (EMCP II) Starting Motor Magnetic Switch - Test - EUI Engines Only
Electronic Modular Control Panel II (EMCP II) Starting Motor Magnetic Switch - Test - 3306B and 3406C MUI Engines
3406E Engine Engine Oil Cooler - Remove
3054 and 3056 Marine Generator Set Engines Auxiliary Water Pump - Install
3126B Industrial Engine Fuel Transfer Pump - Install
3126B Industrial Engine Fuel Transfer Pump - Remove
3054, 3054B and 3056 Marine Engines Marine Transmission Oil Cooler - Remove and Install - 3056 Engine
3406E Engine Air Compressor - Remove and Install
C9 Engine For Caterpillar Built Machines Turbocharger - Remove
Electronic Modular Control Panel II (EMCP II) Troubleshooting Dedicated Shutdown Indicators
320D and 323D Excavators Machine System Specifications Pilot Valve (One Way)
Electronic Modular Control Panel II (EMCP II) Starting Motor Magnetic Switch - Test - PEEC Engines Only
2000/10/01 New Jake Brake Housing {1119, 1129}
3618 Engine Specifications
3608 Engine Plate Locations and Film Locations
3054, 3054B and 3056 Marine Engines Water Temperature Regulator Housing - Remove and Install - 3056 Engine
3116 On Highway Engines Pistons and Connecting Rods - Disassemble
3116 On Highway Engines Pistons and Connecting Rods - Remove