Electronic Control Module - Remove and Install
拆卸步骤
- 将燃油管路从燃油冷却 ECM(如果配备)上拆下。
- 松开螺钉 (1) ,直到可以断开线束 (4) 为止。 将线束 (4) 从电子控制模块 (2) 上断开。
Show/hide table
图 1 | g00609591 |
典型实例 |
- 拆下四条螺栓 (3) 。 将电子控制模块从发动机上拆下。
安装步骤
- 将电子控制模块 (2) 定位到发动机上后安装四条螺栓 (3) 。
Show/hide table
图 2 | g00609591 |
典型实例 |
- 将线束 (4) 连接到电子控制模块 (2) 上。 将螺钉 (1) 上紧到 6 ± 1 N·m (53 ± 9 lb in) 的扭矩。
- 将燃油管路重新连接到燃油冷却 ECM(如果配备)上。
Caterpillar Information System:
3500 Engines For Caterpillar Built Power Modules Crankshaft Position for Fuel Injector Adjustment and Valve Lash Setting
C9 Urban Transit Bus Engine Customer Specified Parameters Worksheet
PM3412C Power Modules Machine Lifting
PM3500 Power Modules Cooling System Coolant (ELC) - Change
PM3500 Power Modules Cooling System Coolant (DEAC) - Change
3126E On-highway Engine System Overview
3126B and 3126E On-highway Engines Engine Running Output Circuit - Test
3126B Engines for Caterpillar Built Machines Front Cover - Install
3126B Engines for Caterpillar Built Machines Front Cover - Remove
3500 Generator Set Engines Electronic Governors
3126B Engines for Caterpillar Built Machines Idler Pulley - Remove and Install
3126B Engines for Caterpillar Built Machines Water Pump - Install
3126B and 3126E On-highway Engines Input Selection Switch Circuit - Test
Machine Security System General Information
Machine Security System General Information
Machine Security System System Schematic
Machine Security System Electronic Control Module (ECM) - Replace
SPS343 Skid Mounted Pumper Safety Messages
PM3500 Power Modules Fuel System - Fill
2000/08/28 New Hydraulic Oil Coolers with Copper-Nickel Alloy Tubes Resist Corrosion {1374}
2000/08/28 New Hydraulic Oil Coolers with Copper-Nickel Alloy Tubes Resist Corrosion {1374}
JF Series Starting Motor Pinion Does Not Engage Ring Gear While Armature Turns
3126B and 3126E On-highway Engines Exhaust Brake Circuit - Test
G3406 Engine Measuring Exhaust Temperature