Ensure that all of the messages are legible. Clean the messages or replace the messages if the words cannot be read or if the illustrations are not visible. Use a cloth, water, and soap for cleaning the messages. Do not use solvents, gasoline, or other harsh chemicals. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the messages. The messages that are loosened could drop off of the engine.
Replace any message that is damaged or missing. If a message is attached to a part of the engine that is replaced, install a new message on the replacement part. Your Caterpillar dealer can provide new messages.
The safety messages that may be attached on the engine are illustrated and described below.
Crankcase Covers
Illustration 1 | g00386802 |
Location of the safety message for the crankcase covers |
The safety messages for the crankcase covers are located on the crankcase covers.
g00123185 |
Flash fire may result in personal injury, if crankcase covers are removed within fifteen minutes after emergency shut down. Do not restart engine until cause for shutdown has been corrected. |
Engine Lifting
Illustration 2 | g00580494 |
Location of the safety message for lifting the engine |
The safety message for lifting the engine is located on the valve covers.
g00306083 |
Improper lift rigging can allow unit to tumble causing injury and damage. |
Before lifting the engine, read this Operation and Maintenance Manual, "Engine Lifting" topic (Operation Section).
If improper equipment is used to lift the engine, injury and damage can occur. Use cables that are properly rated for the weight. Use a spreader bar and attach the cables according to the information on the warning label.
Fuel Injectors
Illustration 3 | g00749734 |
Locations of the safety message for the fuel injectors |
The safety message for the fuel injectors is located on the electronic control module (ECM) (1) and the valve covers (2) .
g00103125 |
Electrical shock hazard. The electronic unit injector system uses 90-120 volts. |
The ECM sends a high voltage signal to the fuel injectors. To help prevent personal injury, disconnect the fuel injector connector. Do not come in contact with the harness connector for the fuel injector while the engine is operating.