Machine Lifting
The power module may need to be lifted by a crane from one position to another position. Two cranes are recommended in order to lift the power module. This will reduce unnecessary stress on the power module. The recommended height for the hook is 6 m (20 ft).
Show/hide table
 | |
| Illustration 1 | g00728446 |
Caterpillar Information System:
PM3500 Power Modules Cooling System Coolant (ELC) - Change
PM3500 Power Modules Cooling System Coolant (DEAC) - Change
3126E On-highway Engine System Overview
3126B and 3126E On-highway Engines Engine Running Output Circuit - Test
3126B Engines for Caterpillar Built Machines Front Cover - Install
3126B Engines for Caterpillar Built Machines Front Cover - Remove
3500 Generator Set Engines Electronic Governors
3126B Engines for Caterpillar Built Machines Idler Pulley - Remove and Install
3126B Engines for Caterpillar Built Machines Water Pump - Install
3126B Engines for Caterpillar Built Machines Water Pump - Remove
2000/08/01 New Gaskets, Prechamber Assembly, and Ignition Body Assembly Are Used In Prechamber Groups {1106, 1250, 7555}
SR4 and SR4B Electric Power Generation Rewind Data Terminology
C9 Urban Transit Bus Engine Customer Specified Parameters Worksheet
3500 Engines For Caterpillar Built Power Modules Crankshaft Position for Fuel Injector Adjustment and Valve Lash Setting
3126B Engines for Caterpillar Built Machines Electronic Control Module - Remove and Install
3126B and 3126E On-highway Engines Input Selection Switch Circuit - Test
Machine Security System General Information
Machine Security System General Information
Machine Security System System Schematic
Machine Security System Electronic Control Module (ECM) - Replace
SPS343 Skid Mounted Pumper Safety Messages
PM3500 Power Modules Fuel System - Fill
2000/08/28 New Hydraulic Oil Coolers with Copper-Nickel Alloy Tubes Resist Corrosion {1374}
2000/08/28 New Hydraulic Oil Coolers with Copper-Nickel Alloy Tubes Resist Corrosion {1374}