120H and 135H Motor Graders Caterpillar


Parking

Usage:

120H 124
將機器停放在水平表面上。 如果必須停駐在斜坡上,請用適合的擋塊阻擋機器的輪子。 考慮以下項目:

  • 輪胎尺寸

  • 機器重量

  • 地面情況

啟用行車煞車以停止機器。 將變速箱控制裝置 (操縱桿) 移至 NEUTRAL (空檔) 位置。 將油門控制裝置切換至 LOW IDLE (低怠速) 位置。

啟用駐車煞車。

將所有設備降至地面。 啟動所有控制鎖。

關閉引擎。

將引擎起動開關調至 OFF (關閉) 位置,並取下引擎起動開關鑰匙。

將蓄電池斷路開關切換至 OFF (關閉) 位置。 如果長時間不操作機器,請取下斷路開關鑰匙。 這樣做可以防止蓄電池放電。 電池短路、來自某些元件的任何電流消耗以及蓄意破壞行為都有可能造成蓄電池放電。

Caterpillar Information System:

3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Auxiliary Brake Circuit - Test
G3408C and G3412C Engines Actuator Control Linkage - Lubricate
G3406 and G3412 Generator Sets Control Panel
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers CID 0254 FMI 12 Electronic Control Module Error
3034 Engine for Caterpillar Built Machines Turbocharger - Inspect
G3408C and G3412C Engines Gas Pressure Regulator - Check
3126B and 3126E On-highway Engines Engine Cranks but Will Not Start
120H and 135H Motor Graders Tire Information
G3516B Engines E270 Driven Equipment Shutdown Requested
3126B and 3126E On-highway Engines Electronic Service Tool Will Not Communicate with ECM
G3516B Engines E269 Customer Shutdown Requested
G3516B Engines E268 Unexpected Engine Shutdown
SR4 and SR4B Electric Power Generation Rewind Data Winding Data for <B>4P-2236</B> Generator through <B>4P-9907</B> Generator
G3516B Engines E401 Cylinder #1 Detonation
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers CID 0100 FMI 03 Engine Oil Pressure open/short to +batt
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Engine Running Output Circuit - Test
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers CID 0100 FMI 04 Engine Oil Pressure short to ground
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Engine Shutdown Output Circuit - Test
G3516B Engines E801 Cylinder #1 High Exhaust Port Temp
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers CID 0172 FMI 03 Intake Manifold Air Temp open/short to +batt
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers CID 0172 FMI 04 Intake Manifold Air Temp short to ground
3176C and 3196 Engines for Caterpillar Built Machines CID 0174 FMI 03 Fuel Temperature open/short to +batt
3176C and 3196 Engines for Caterpillar Built Machines CID 0174 FMI 04 Fuel Temperature short to ground
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers CID 0262 FMI 04 5 Volt Sensor DC Power Supply short to ground
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.