Corrections To Specifications Modules, G3600 Engines , "Piston and Rings" {1214, 1215}
- Engines:
- G3606 (S/N: 3XF)
- G3608 (S/N: 4WF)
- G3612 (S/N: 1YG)
- G3616 (S/N: 4CG)
In the identified Specifications modules, footnotes 1 and 2 are not correct. The correct information follows:
- (1) The top ring must be installed with the "UP-1" mark toward the top of the piston.
- (2) The intermediate ring must be installed with the "UP-2" mark toward the top of the piston.
Caterpillar Information System:
Alternator - Delco 21SI Capacitor - Test
325, 325B and 325L Excavators Swing Gear and Bearing - Install
325, 325B and 325L Excavators Swing Gear and Bearing - Remove
325, 325B and 325L Excavators Swivel - Install
325, 325B and 325L Excavators Swivel - Assemble
325, 325B and 325L Excavators Swivel - Disassemble
325, 325B and 325L Excavators Swivel - Remove
HDB Series and M1 Series Heavy Duty Brushless Alternators Service Tools
325, 325B and 325L Excavators Final Drive - Install
325, 325B and 325L Excavators Final Drive - Assemble
325, 325B and 325L Excavators Final Drive - Disassemble
325, 325B and 325L Excavators Final Drive - Remove
3408E and 3412E Engines for Caterpillar Built Machines E164 High Injector Actuation Pressure
3612 and 3616 Engines Engine Barring Group
3034 Engine for Caterpillar Built Machines Finding Top Center Position for No. 1 Piston
G3516B Engines MID 036 - CID 0444 - FMI 05 Start Relay open circuit
G3408 and G3412 Engines Alarms and Shutoffs
3114, 3116, and 3126 Engines Air Inlet and Exhaust System - Inspect
G3300 Engines General Hazard Information
3408E and 3412E Industrial Engines Turbocharger Oil Lines
G3516B Engines MID 036 - CID 0444 - FMI 06 Start Relay short to ground
G3516B Engines MID 036 - CID 0445 - FMI 03 Run Relay short to +batt
G3516B Engines MID 036 - CID 0524 - FMI 04 Desired Engine Speed Sensor short to ground
G3516B Engines MID 036 - CID 0524 - FMI 03 Desired Engine Speed Sensor short to +batt