Swivel - Disassemble
Disassembly Procedure For The Swivel On CIPI Undercarriage Arrangements Which Are Based On 325, 325B, and 325C Track Type Excavators
Start By:
- Remove the swivel joint.
Reference: Refer to Disassembly and Assembly, "Swivel - Remove" in this manual.
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Thoroughly clean the outside of the swivel joint prior to disassembly.
- Remove four bolts (1) and cover (2) from outside housing (8). Remove O-ring seal (4) from outside housing (8) .
Show/hide table
Illustration 1 | g00515028 |
- Remove two bolts (5), the washers, and retainer (7) from rotor (9). Remove outside housing (8) from rotor (9) .
- Turn the outside housing upside-down, and remove O-ring seals (6) and seals (3) from the outside housing.
Caterpillar Information System:
325, 325B and 325L Excavators Swivel - Remove
HDB Series and M1 Series Heavy Duty Brushless Alternators Service Tools
325, 325B and 325L Excavators Final Drive - Install
325, 325B and 325L Excavators Final Drive - Assemble
325, 325B and 325L Excavators Final Drive - Disassemble
325, 325B and 325L Excavators Final Drive - Remove
325, 325B and 325L Excavators Travel Motor - Install
325, 325B and 325L Excavators Travel Motor - Assemble
3114, 3116, and 3126 Engines Governor - Adjust
325, 325B and 325L Excavators Travel Motor - Disassemble
325, 325B and 325L Excavators Travel Motor - Remove
325, 325B and 325L Excavators Travel Brake Valve - Install
325, 325B and 325L Excavators Swivel - Assemble
325, 325B and 325L Excavators Swivel - Install
325, 325B and 325L Excavators Swing Gear and Bearing - Remove
325, 325B and 325L Excavators Swing Gear and Bearing - Install
Alternator - Delco 21SI Capacitor - Test
2000/05/01 Corrections To Specifications Modules, G3600 Engines , "Piston and Rings" {1214, 1215}
3408E and 3412E Engines for Caterpillar Built Machines E164 High Injector Actuation Pressure
3612 and 3616 Engines Engine Barring Group
3034 Engine for Caterpillar Built Machines Finding Top Center Position for No. 1 Piston
G3516B Engines MID 036 - CID 0444 - FMI 05 Start Relay open circuit
G3408 and G3412 Engines Alarms and Shutoffs
3114, 3116, and 3126 Engines Air Inlet and Exhaust System - Inspect