Twin Turbocharger Configuration
Illustration 1 | g00364897 |
Rear view of engine |
Illustration 2 | g00364898 |
Right side of the engine |
(1) Apply 5P-3413 Pipe Sealant to the threads of the studs.
(2) Lubricate the seal bores lightly with glycerin or with clean engine oil.
(3) Rear face of cylinder block
Series Turbocharger Configuration
Illustration 3 | g00365512 |
Right side of cylinder block |
(1) (2) Lubricate the O-ring seals with a thin layer of glycerin or with clean engine oil.
(X) The clamp must be installed at the following distance. ... 150.0 ± 25.0 mm (5.91 ± 0.98 inch)
Illustration 4 | g00365513 |
Right side rear view |
(3) (4) Lubricate the O-ring seals with a thin layer of glycerin or with clean engine oil.
Illustration 5 | g00365514 |
Left side rear view |
(5) (6) Lubricate the O-ring seals with a thin layer of glycerin or with clean engine oil.
Illustration 6 | g00365516 |
Left side of cylinder block |
(7) Lubricate the O-ring seals with a thin layer of glycerin or with clean engine oil.
(8) Use 5P-3413 Pipe Sealant on the threads of the studs before assembly.
(9) Lubricate the O-ring seals with a thin layer of glycerin or with clean engine oil.
Single Turbocharger Configuration
Illustration 7 | g00364833 |
Rear view |
(1) Apply 5P-3931 Anti-Seize Compound to the threads before assembly.
(2) Apply 5P-3413 Pipe Sealant to the threads before assembly.
(3) Lubricate the bore lightly with the lubricant that is being sealed.
Illustration 8 | g00364836 |
(4) Lubricate the bore lightly with clean engine oil.