Fan - Remove and Install
Removal Procedure
Show/hide table
Illustration 1 | g00701501 |
Typical example |
- Remove four bolts (1) .
- Remove fan (2) .
- Remove the fan pulley, if necessary.
Installation Procedure
Show/hide table
Illustration 2 | g00701501 |
Typical example |
- Inspect the condition of the fan pulley. Replace the fan pulley, if necessary.
- Install fan (2) .
- Install four bolts (1). Tighten the bolts to a torque of 22 N·m (16 lb ft).
Caterpillar Information System:
G3406 Engine Model View Illustrations
3176C and 3196 Engines for Caterpillar Built Machines Camshaft
3114, 3116, and 3126 Engines Fuel System Pressure - Test
G3408 and G3412 Engines Gauges and Indicators
3034 Engine for Caterpillar Built Machines Piston Cooling Jets - Remove and Install
3618 Engine Annunciator Panel - Inspect
3114, 3116, and 3126 Engines Fuel System - Prime
3034 Engine for Caterpillar Built Machines Camshaft - Install
G3516B Engines +5V Sensor Voltage Supply
3126B Marine Engine Aftercooler Condensate Drain Valve - Inspect/Clean
2000/04/01 Revised Troubleshooting Module Available {1000}
3034 Engine for Caterpillar Built Machines Camshaft - Remove
3114, 3116, and 3126 Engines Fuel Timing Dimension - Adjust
3034 Engine for Caterpillar Built Machines Crankshaft Gear - Remove and Install
584 and 584HD Forwarders General Hazard Information
325, 325B and 325L Excavators Part Number Location
325, 325B and 325L Excavators Final Drive Ring Gear Removal
120H and 135H Motor Graders Fire Prevention and Explosion Prevention
SR4 and SR4B Electric Power Generation Rewind Data Winding Data for <B>121-6882</B> Generator through <B>123-3185</B> Generator
2000/09/11 170-9227 Shims Will Control Injector Sleeve Reaming {0700, 0703, 0706, 1000}
325, 325B and 325L Excavators S·O·S Oil Analysis
325, 325B and 325L Excavators Refill Capacities
3114, 3116, and 3126 Engines Unit Injector - Adjust
2000/04/01 New Turbocharger Compressor Cover is now Available {1052}