Camshaft
Show/hide table
Illustration 1 | g01334458 |
(2) Camshaft (3) Woodruff key (4) Camshaft drive gear (5) Cylinder block |
(A) Diameter of new camshaft journals ... 74.850 ± 0.025 mm (2.9468 ± 0.0010 inch)
(1) Torque for thrust pin ... 28 ± 7 N·m (21 ± 5 lb ft)
Show/hide table
Illustration 2 | g01415161 |
(B) Specified camshaft lobe lift
- Exhaust lobe ... 9.550 mm (0.3760 inch)
- Inlet lobe ... 11.371 mm (0.4477 inch)
- Injector lobe ... 10.474 mm (0.4124 inch)
- Inlet lobe ... 11.371 mm (0.4477 inch)
Use the following procedure to find the actual camshaft lobe lift:
- Measure the camshaft lobe height (C) .
- Measure the base circle (D) .
- Subtract the base circle (D) from the lobe height (C) . The difference is the actual camshaft lobe lift (B) .
The maximum permissible difference between the actual camshaft lobe lift and the specified camshaft lobe lift of a new camshaft is ± 0.13 mm (± 0.005 inch).
Caterpillar Information System:
3114, 3116, and 3126 Engines Fuel System Pressure - Test
G3408 and G3412 Engines Gauges and Indicators
3034 Engine for Caterpillar Built Machines Piston Cooling Jets - Remove and Install
3618 Engine Annunciator Panel - Inspect
3114, 3116, and 3126 Engines Fuel System - Prime
3034 Engine for Caterpillar Built Machines Camshaft - Install
G3516B Engines +5V Sensor Voltage Supply
3126B Marine Engine Aftercooler Condensate Drain Valve - Inspect/Clean
2000/04/01 Revised Troubleshooting Module Available {1000}
3034 Engine for Caterpillar Built Machines Camshaft - Remove
2000/12/01 A New Electronic Actuator Is Used In Gas Pressure Regulator Groups That Are On Engines That Have Air/Fuel Ratio Control Systems {1716}
G3406 Engine Safety Messages
G3406 Engine Model View Illustrations
3034 Engine for Caterpillar Built Machines Fan - Remove and Install
3114, 3116, and 3126 Engines Fuel Timing Dimension - Adjust
3034 Engine for Caterpillar Built Machines Crankshaft Gear - Remove and Install
584 and 584HD Forwarders General Hazard Information
325, 325B and 325L Excavators Part Number Location
325, 325B and 325L Excavators Final Drive Ring Gear Removal
120H and 135H Motor Graders Fire Prevention and Explosion Prevention
SR4 and SR4B Electric Power Generation Rewind Data Winding Data for <B>121-6882</B> Generator through <B>123-3185</B> Generator
2000/09/11 170-9227 Shims Will Control Injector Sleeve Reaming {0700, 0703, 0706, 1000}
325, 325B and 325L Excavators S·O·S Oil Analysis
325, 325B and 325L Excavators Refill Capacities