Elevated Idle
This condition does not indicate an electronic system problem. The low idle speed may be elevated due to the following feature:
- Low battery voltage elevated idle
Note: The "Elevated Idle" status flag will be activated if the above feature is active.
Low Battery Voltage Elevated Idle
The engine idle speed will be elevated to 1200 rpm when all of the following conditions occur:
- System battery voltage is less than 24.5 VDC for five minutes.
- The low/high idle switch is set to low idle for five minutes.
- The machine is not in gear.
Caterpillar Information System:
VHS-10, VHS-30, VHS-40, VHS-50, VHS-60 and VHS-70 Demolition and Scrap Shears Cutting Edge
C7 and C9 Engines for Caterpillar Built Machines Injection Actuation Pressure Control Valve Circuit - Test
325C LCR Excavator Machine Systems Pilot Valve (Control Pattern Change) - Assemble
2005/03/21 An Improved Auger Shaft is Now Used {4054, 6282, 7000}
325C LCR Excavator Machine Systems Pilot Valve (Control Pattern Change) - Disassemble
2005/04/04 An Improved Pin Lock Group for Quick Couplers is Now Available {6129, 6700}
GENSET, SR4, SR4 HV, SR4B and SR4B HV Electric Power Generation, 3126, 3176B, 3176C, 3196, 3408E, 3412C, 3412E, 3508, 3508B, 3512, 3512B, 3516, 3516B and G3616 Engines, 3406E GEN SET Generator Set, 3406E IND, 3408C IND and 3456 IND Industrial Engines Sea Water Module Interface
2005/03/01 The Cylinder Liners Have a New Appearance {1216}
VHS-10, VHS-30, VHS-40, VHS-50, VHS-60 and VHS-70 Demolition and Scrap Shears Cutting Edge
2005/03/14 The Cylinder Liners Have a New Appearance {1216}
C27 and C32 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Assemble
325C LCR Excavator Machine Systems Operator Console - Remove and Install
M325D Material Handler Machine Systems Stick Cylinder - Remove and Install
2005/07/18 New Seals on the Shaft of the Main Pump and the Shaft of the Swing Pump Prevents Leaks {5070}
BH27, BH30 and BH30 W Skid Steer Loader Backhoes Safety Messages
302.5C Mini Hydraulic Excavator Machine System Specifications Main Hydraulic Pump
994F Wheel Loader Hydraulic System Electronic Control Module (ECM) - Replace
S320B, S325B, S340B, S365B and S385B Demolition and Scrap Shears Wear Plates - Inspect/Replace
345C Excavator Tool Control System Relay (Hydraulic Activation)
C9 Engines for Caterpillar Built Machines Unit Injector Hydraulic Pump - Remove
S320B, S325B, S340B, S365B and S385B Demolition and Scrap Shears Wear Tip - Inspect/Replace
BR160, BR166, BR172, BR272 and BR378 Brush Cutters Additional Messages
C9 Engines for Caterpillar Built Machines Unit Injector Hydraulic Pump - Install
BH150 Backhoes and BH160 Backhoes For Skid Steer Loaders and Multi Terrain Loaders Specifications