Installation Procedure
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 129-6671     | Reaction Sleeve     | 1     |
129-6672 | Puller Plate     | 1     | |
129-6673 | Bearing Pilot     | 1     | |
129-6674 | Backup Plate     | 1     | |
6F-7032 | Bolt     | 1     | |
1P-5542 | Taper Lock Stud     | 1     |
Note: All of the tools that are listed above are used with the 8S-2241 Camshaft Bearing Tool Group.
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Position the new bearing (2) in Tool (A) and install the bearings one at a time from the rear of the engine to the front of the engine.
Illustration 1 | g00516213 |
NOTICE |
---|
Location of the camshaft bearing lubrication holes is critical. Position the clinch butt joint up for all seven camshaft bearings. The No. 1 camshaft bearing oil hole is located 115 degrees counter clockwise from top center to align with the oil supply passage in the block. Camshaft bearings No. 2 through No. 7 are installed with the oil hole 45 degrees clockwise from top center. All are viewed from the front of the engine. Camshaft bearings 1,2,3,4,5, and 6 are the same width. Camshaft bearing No. 7 has a smaller width. Refer to the Specifications Manual for more information. |
End By:
- Install the camshaft.
- Install the lifter assembly.