Connecting Rod Bearings - Remove
Removal Procedure
Start By:
- Remove the engine oil pan.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Inspect the connecting rod and connecting rod cap (2) for the proper identification mark. The connecting rod and connecting rod cap (2) should have an etched number on the side that is toward the right side of the engine. The number should match the cylinder number. The bearing retainer notch should also be on the right side. Mark the connecting rod and connecting rod cap (2), if necessary.
Show/hide table
Illustration 1 | g00522734 |
- Remove connecting rod cap bolts (1) and connecting rod cap (2) .
- Remove the lower half of the connecting rod bearing from connecting rod cap (2) .
- Push connecting rod (3) away from the crankshaft. Remove the upper half of connecting rod bearing (4) .
Show/hide table
Illustration 2 | g00522735 |
- Repeat Steps 1 through 4 in order to remove the remaining connecting rod bearings.
Caterpillar Information System:
3512B Petroleum Engines Air Filter Restriction
3500B Engines Electronic Control Module (ECM)
3176C and 3196 Marine Engines Camshaft Gear - Remove and Install
2000/01/01 The New Bendix DuraFlo 596 Air Compressor Has Reduced Maintenance Costs {1803}
Customer Communication Module (CCM) for Diesel Engines RS-232C Cable Requirements
2000/01/01 A Socket Setscrew (Orifice) Is Used In The Oil Rail Of The Hydraulic Electronic Unit Injector (HEUI) Fuel System {1100}
3176C and 3196 Marine Engines Camshaft Bearings - Install
2000/04/01 A New Flexible High Pressure Oil Supply Hose Assembly Is Used In The Hydraulic Electronic Unit Injector (HEUI) Fuel System {1307, 1714}
Electronic Modular Control Panel II+ (EMCP II+) Data Link
3500B High Displacement Engines Low Coolant Temperature
3500B High Displacement Engines High Coolant Temperature
3176C and 3196 Marine Engines Camshaft Bearings - Remove
3500B High Displacement Engines Engine Overspeed Control
3176C and 3196 Marine Engines Connecting Rod Bearings - Install
3500B High Displacement Engines Altitude Derate Feature
2000/03/01 New Software for the 3196 Marine Engines {7620}
Alternator - Delco 21SI Normal Operation
3176C and 3196 Marine Engines Fuel Priming Pump - Remove and Install
3500B High Displacement Locomotive Engines Exhaust Manifold
3500B High Displacement Engines Pressure Sensor for Turbocharger Compressor Outlet
2000/02/01 New Alternator Mounting Bracket Now Used {1405}
3176C and 3196 Marine Engines Fuel Filter Base - Remove and Install
2000/02/01 New Software for 3412C PEEC III Engines {7620}
2000/02/01 Software Part Number Reference in TMI {7620}