Water Outlet Manifold - Remove
Removal Procedure
Start By:
- Remove the fan drive. Refer to Disassembly and Assembly, "Fan Drive - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Drain the coolant from the cooling system into a suitable container for storage or disposal.
- Loosen hose clamp (3) and move the hose clamp toward the water pump.
Show/hide table
Illustration 1 | g00645228 |
- Remove six bolts (1) that hold water outlet manifold (2) in position.
- Remove water outlet manifold (2) and the gasket from the engine. Inspect the gasket for damage. If the gasket is damaged, use a new part for replacement.
Caterpillar Information System:
Caterpillar Monitoring System for Electronic Modular Control Panel CID 0827 FMI 08 Temperature Sensor (Left Exhaust) Abnormal Signal - Test
G3412C, G3508, G3512, G3516, G3606, G3608, G3612 and G3616 Engines Customer Communication Module General Wiring Diagram
3612 and 3616 Engines Crankshaft Main Bearings - Install
3618 Engine Piston and Connecting Rods - Remove
3126B Marine Engine Water Pump - Install
3126 Truck Engine Military Air Inlet Heater - Remove and Install
3126B Marine Engine Water Pump - Remove
3612 and 3616 Engines Crankshaft - Remove
3618 Engine Piston Cooling Jets - Remove and Install
Customer Communication Module (CCM) for Diesel Engines Acronyms
3054B Industrial Engine Exhaust Manifold - Remove and Install
3612 and 3616 Engines Cylinder Liner - Remove
3126B Marine Engine Water Temperature Regulator - Remove and Install
3126B Marine Engine Water Pump - Disassemble
3612 and 3616 Engines Crankshaft - Install
3054B Industrial Engine Water Outlet Manifold - Install
3618 Engine Piston and Connecting Rods - Install
3054B Industrial Engine Valve Mechanism Cover - Remove and Install
3054B Industrial Engine Fan Drive - Remove
3126B Marine Engine Engine Oil Cooler - Remove
3126B Marine Engine Engine Oil Cooler - Install
3054B Industrial Engine Fan Drive - Install
3512B Marine Auxiliary Engine Low Idle/High Idle Switch
SR4 HV and SR4B HV Generators Continuous Operation