Water Pump - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Clean the mating surface of the water pump and the cylinder block.
- Inspect the condition of the O-ring seal. Replace the O-ring seal, if necessary.
- Install the O-ring seal on the water pump.
- Position water pump (9) on the engine. Install four bolts (11) .
Show/hide table
Illustration 1 | g00743477 |
- Install oil tube (10) .
- Position pulley (7) on water pump (9) .
Show/hide table
Illustration 2 | g00744933 |
- Install bolts (8) and the washers that fasten pulley (7) to water pump (9) .
- Tighten hose clamp (6) .
Show/hide table
Illustration 3 | g00744868 |
- Install hose (4) and tighten hose clamp (5) .
Show/hide table
Illustration 4 | g00744867 |
- Install hose (2) and tighten hose clamp (3) .
- Install oil filter (1) .
Show/hide table
Illustration 5 | g00743436 |
- Fill the cooling system with coolant to the correct level. Refer to the Operation and Maintenance Manual, "Refill Capacities" for the correct level.
End By: Install the belt tensioner. Refer to Disassembly and Assembly, "Belt Tensioner - Remove and Install".
Caterpillar Information System:
3126 Truck Engine Military Air Inlet Heater - Remove and Install
3126B Marine Engine Water Pump - Remove
3612 and 3616 Engines Crankshaft - Remove
3618 Engine Piston Cooling Jets - Remove and Install
Customer Communication Module (CCM) for Diesel Engines Acronyms
3054B Industrial Engine Exhaust Manifold - Remove and Install
3612 and 3616 Engines Cylinder Liner - Remove
3126 Truck Engine Military Unit Injector Hydraulic Pump - Install
3126B Marine Engine Alternator - Remove and Install
Caterpillar Monitoring System for Electronic Modular Control Panel CID 0263 FMI 03 Sensor Power Supply Voltage Above Normal - Test
3126 Truck Engine Military Unit Injector Hydraulic Pump - Remove
3126B Marine Engine Aftercooler - Assemble
3618 Engine Piston and Connecting Rods - Remove
3612 and 3616 Engines Crankshaft Main Bearings - Install
G3412C, G3508, G3512, G3516, G3606, G3608, G3612 and G3616 Engines Customer Communication Module General Wiring Diagram
Caterpillar Monitoring System for Electronic Modular Control Panel CID 0827 FMI 08 Temperature Sensor (Left Exhaust) Abnormal Signal - Test
3054B Industrial Engine Water Outlet Manifold - Remove
3126B Marine Engine Water Temperature Regulator - Remove and Install
3126B Marine Engine Water Pump - Disassemble
3612 and 3616 Engines Crankshaft - Install
3054B Industrial Engine Water Outlet Manifold - Install
3618 Engine Piston and Connecting Rods - Install
3054B Industrial Engine Valve Mechanism Cover - Remove and Install
3054B Industrial Engine Fan Drive - Remove