Caterpillar 270 Air Compressor Caterpillar


General Testing and Adjusting Information

Usage:

C13 LEE
Always use care when you service the air compressor. Read the warnings and understand the warnings. Read the notices and understand the notices.

------ WARNING! ------

Before you disconnect any line from the air compressor, purge the system of pressurized air.

Failure to purge the pressurized air before you service the air compressor can result in personal injury.

----------------------

------ WARNING! ------

Hot engine components can cause injury from burns. Before performing maintenance on the engine, allow the engine and the components to cool.

----------------------

------ WARNING! ------

Personal injury can result from rotating and moving parts.

Stay clear of all rotating and moving parts.

Never attempt adjustments while the machine is moving or the engine is running unless otherwise specified.

The machine must be parked on a level surface and the engine stopped.

----------------------


NOTICE

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.

Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.

Dispose of all fluids according to local regulations and mandates.



NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.


Caterpillar Information System:

Bendix DuraFlo 596 Air Compressor Air Compressor Fails to Unload
3618 Engine Crankshaft Front Seal and Wear Sleeve - Install
3612 and 3616 Engines Engine Oil Pan - Disassemble
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Schematics and Wiring Diagrams
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines EMCP Electronic Control (Generator Set) - Flash Program
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Connector Contact Identification of Generator Set Control
3056 Engine for Caterpillar Built Machines Crankshaft Rear Seal - Install
3612 and 3616 Engines Engine Oil Pan - Install
Bendix DuraFlo 596 Air Compressor Air Compressor Maintenance Procedures
3126B Truck Engine Reference Material
3126B Truck Engine Maintenance Interval Schedule
3126B Truck Engine Refill Capacities
3406E Truck Engine Inlet Air Temperature Sensor
3612 and 3616 Engines Engine Oil Pan - Assemble
C-9 Engines for Caterpillar Built Machines Front Housing and Covers
SR500 Generators Insulation - Test
C9 Engine For Caterpillar Built Machines Camshaft Gear - Remove and Install
C9.3 Engines for Caterpillar Built Machines Camshaft Bearings - Remove and Install
Bendix DuraFlo 596 Air Compressor Excessive Oil at Exhaust Ports or Air Strainer
584 and 584HD Forwarders Emissions Certification Film
Electronic Modular Control Panel II (EMCP II) Component Location
3612 and 3616 Engines Oil Temperature Regulators - Remove and Install
C9 Engine For Caterpillar Built Machines Pistons and Connecting Rods - Remove
SR500 Generators Parallel Operation
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.