Engine Oil Pan - Disassemble
拆解步骤
开始:
- 拆下发动机油底壳。 请参阅拆解和组装, "发动机油底壳 - 拆卸"。
Show/hide table
| 注意 |
|---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
早先的油底壳
- 从壳体卸下滤网 (1) 。
Show/hide table
 | |
| 图 1 | g00632989 |
- 拆下钟形吸油罩 (2) 。 从钟形吸油罩 (2) 上卸下 O 形密封圈。
Show/hide table
 | |
| 图 2 | g00632994 |
- 拆下卡箍 (3) 。
Show/hide table
 | |
| 图 3 | g00632997 |
- 拆下管组件 (4) 。 从管组件 (4) 上卸下 O 形密封圈。
Show/hide table
 | |
| 图 4 | g00632999 |
- 取下壳体 (5) 。 将 O 形密封圈从壳体 (5) 上拆下。
后来的油底壳
- 拆下螺栓 (6) 。 拆下盖 (8) 。 吸油滤网在外部安装在管组件内部的护盖后部。 拆下螺栓 (9) 。 如有必要，拆下三通 (7) 。
Show/hide table
 | |
| 图 5 | g01293429 |
- 拆卸钟形吸油罩 (10) 。
Show/hide table
 | |
| 图 6 | g01293432 |
- 拆下卡箍 (11) 。
Show/hide table
 | |
| 图 7 | g01293434 |
- 拆卸管组件 (12) 。 从管组件 (12) 上拆卸 O 形密封圈。
注: 检查 O 形密封圈是否损坏。 如有必要，更换O形密封圈。
Caterpillar Information System:
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Schematics and Wiring Diagrams
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines EMCP Electronic Control (Generator Set) - Flash Program
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Connector Contact Identification of Generator Set Control
3056 Engine for Caterpillar Built Machines Crankshaft Rear Seal - Install
3612 and 3616 Engines Engine Oil Pan - Install
Bendix DuraFlo 596 Air Compressor Air Compressor Maintenance Procedures
3126B Truck Engine Reference Material
3126B Truck Engine Maintenance Interval Schedule
3126B Truck Engine Refill Capacities
3126B Truck Engine Engine Operation
C-9 Engines for Caterpillar Built Machines Unit Injector
3054 and 3056 Industrial and Generator Set Engines Fan Drive
3618 Engine Crankshaft Front Seal and Wear Sleeve - Install
Bendix DuraFlo 596 Air Compressor Air Compressor Fails to Unload
Caterpillar 270 Air Compressor General Testing and Adjusting Information
3406E Truck Engine Inlet Air Temperature Sensor
3612 and 3616 Engines Engine Oil Pan - Assemble
C-9 Engines for Caterpillar Built Machines Front Housing and Covers
SR500 Generators Insulation - Test
C9 Engine For Caterpillar Built Machines Camshaft Gear - Remove and Install
C9.3 Engines for Caterpillar Built Machines Camshaft Bearings - Remove and Install
Bendix DuraFlo 596 Air Compressor Excessive Oil at Exhaust Ports or Air Strainer
584 and 584HD Forwarders Emissions Certification Film
Electronic Modular Control Panel II (EMCP II) Component Location