Recoil Spring
Show/hide table
Illustration 1 | g00687345 |
(1) Tighten the 154-2237 Valve to the following torque. ... 75 ± 15 N·m (55.3 ± 11.1 lb ft)
(2) Tighten the four 8T-4910 Bolts to the following torque. ... 90 ± 35 N·m (66.4 ± 25.8 lb ft)
(A) Adjust the installed length of the 146-1132 Spring to the following length. ... 204 ± 1.5 mm (8.0 ± 0.06 inch)
(A) The installed pressure of the 146-1132 Spring ... 2130 ± 130 kg (4695.8 ± 286.6 lb)
Caterpillar Information System:
320C Excavator Machine Systems Stick Bearings and Seals - Remove
2000/03/20 Improved Exhaust Manifolds {1059}
320C Excavator Machine Systems Bucket - Install
320C Excavator Fuses - Replace
325C and 325C L Excavator Fuel Tank Water and Sediment - Drain
3508B Engine for 854G Wheel Dozers and 992G Wheel Loaders MID 036 - CID 0298 - FMI 02 Incorrect Service Brake Pedal Switch inputs
325D and 329D Excavators Fuel Tank Cap and Strainer - Clean
2000/03/20 New Bolts and Torque for Securing the TOPS {7325}
2000/04/24 The Reliability of the Window Washers is Increased {7306}
2000/06/19 New Pump Drive Is Used To Improve Service Life {3108}
315C Excavator Fuel System Primary Filter (Water Separator) Element - Replace
312C, 315C, 318C, 319C, 320C, 321C, 322C, 325C, 330C and M325C Excavators and 325C MHPU and 330C MHPU Mobile Hydraulic Power Units Engine and Pump Control - V2 Using Service Mode
320C Excavator Hydraulic System Pump Control (Main Hydraulic) - Main Pump Regulator
3508B Engine for 854G Wheel Dozers and 992G Wheel Loaders MID 036 - CID 0548 - FMI 05 Throttle Lock Lamp open circuit
3508B Engine for 854G Wheel Dozers and 992G Wheel Loaders MID 036 - CID 0548 - FMI 06 Throttle Lock Lamp short
3508B Engine for 854G Wheel Dozers and 992G Wheel Loaders MID 036 - CID 0650 - FMI 12 Harness Code invalid
318C and 319C Excavators Hydraulic System Oil - Change
3524B Engines for 797 and 797B Off-Highway Trucks General Information (Fuel System) - Diesel
P16, P20, P25, P28, P40 and P60 Pulverizers Crushing Arm - Remove
2000/04/17 A Worksheet Is Provided for Testing and Adjusting Procedures {4350, 5050}
3054 Engine Compression - Test
P16, P20, P25, P28, P40 and P60 Pulverizers Crushing Arm - Install
303.5 Mini Hydraulic Excavator Machine Systems Pilot Valve (Joystick) - Disassemble
P16, P20, P25, P28, P40 and P60 Pulverizers Crushing Arm - Remove