MID 036 - CID 0548 - FMI 06 Throttle Lock Lamp short
Conditions Which Generate This Code:
The Electronic Control Module (ECM) detects a short circuit to ground condition. The ECM has been powered up for at least two seconds.
System Response:
The CID-FMI is logged in memory. The CID-FMI may be viewed on a display module or the Caterpillar Electronic Technician (ET).
Test Step 1. Perform the following test: Throttle Lock Lamp
Results:
- OK - Stop.
- REPAIRED, OK - Stop.
Caterpillar Information System:
3508B Engine for 854G Wheel Dozers and 992G Wheel Loaders MID 036 - CID 0548 - FMI 05 Throttle Lock Lamp open circuit
320C Excavator Hydraulic System Pump Control (Main Hydraulic) - Main Pump Regulator
303.5 Mini Hydraulic Excavator Recoil Spring
320C Excavator Machine Systems Stick Bearings and Seals - Remove
2000/03/20 Improved Exhaust Manifolds {1059}
320C Excavator Machine Systems Bucket - Install
320C Excavator Fuses - Replace
325C and 325C L Excavator Fuel Tank Water and Sediment - Drain
3508B Engine for 854G Wheel Dozers and 992G Wheel Loaders MID 036 - CID 0298 - FMI 02 Incorrect Service Brake Pedal Switch inputs
325D and 329D Excavators Fuel Tank Cap and Strainer - Clean
2000/03/20 New Bolts and Torque for Securing the TOPS {7325}
2000/04/24 The Reliability of the Window Washers is Increased {7306}
3508B Engine for 854G Wheel Dozers and 992G Wheel Loaders MID 036 - CID 0650 - FMI 12 Harness Code invalid
318C and 319C Excavators Hydraulic System Oil - Change
3524B Engines for 797 and 797B Off-Highway Trucks General Information (Fuel System) - Diesel
P16, P20, P25, P28, P40 and P60 Pulverizers Crushing Arm - Remove
2000/04/17 A Worksheet Is Provided for Testing and Adjusting Procedures {4350, 5050}
3054 Engine Compression - Test
P16, P20, P25, P28, P40 and P60 Pulverizers Crushing Arm - Install
303.5 Mini Hydraulic Excavator Machine Systems Pilot Valve (Joystick) - Disassemble
P16, P20, P25, P28, P40 and P60 Pulverizers Crushing Arm - Remove
P16, P20, P25, P28, P40 and P60 Pulverizers Crushing Arm - Install
312C, 315C, 318C, 319C, 320C, 321C, 322C, 325C, 330C and M325C Excavators and 325C MHPU and 330C MHPU Mobile Hydraulic Power Units Engine and Pump Control - V2 Adjust Clock Mode
320C Excavator Machine Systems Swivel - Remove