Valve Train Noise
- Excessive valve lash
- Damage to valve train components
- Insufficient lubrication
Check the valve lash. Ensure that the valve lash is adjusted to the correct specification. Refer to Systems Operation, Testing And Adjusting, "Valve Lash".
Damage to the Valve Train Components
Inspect the following valve train components:
- Valves
- Springs
- Camshaft
- Lifters
- Retainers
- Pushrods
- Rocker arms
Check for worn parts or damaged parts. Replace damaged parts and also replace parts that are significantly worn.
Check the lubrication in the valve compartment. There must be a small flow of oil at low engine speeds. There must be a strong flow of oil at high engine speeds. Oil passages must be clean. The oil passages that carry the oil to the cylinder head are particularly important.
Caterpillar Information System:
C9 On-Highway Truck Engines Air Compressor - Remove and Install
3612 and 3616 Engines Piston Cooling Jets - Remove and Install
3114, 3116 and 3126 Engines Unit Injector Misfire
3126B Engines for Caterpillar Built Machines Inlet and Exhaust Valve Guides - Remove and Install
3114, 3116 and 3126 Engines Soot in Inlet Manifold
3126B Engines for Caterpillar Built Machines Engine Oil Filter Base - Assemble
C9 Engine For Caterpillar Built Machines Fuel Priming Pump - Remove and Install
3126B Truck Engine Unit Injector - Install
3126B Engines for Caterpillar Built Machines Engine Oil Filter Base - Disassemble
3126B Engines for Caterpillar Built Machines Engine Oil Filter Base - Install
3034 Industrial Engine Fuel Lines
SR4B Generators Insulation - Test
3114, 3116 and 3126 MUI Engine Governors Governor (Type VI) - Assemble
3114, 3116 and 3126 Engines Unit Injector
3612 and 3616 Engines Piston and Connecting Rods - Install
SR4B Generators Service Tools
G3612 and G3616 Engines Cylinder Liner - Remove
G3612 and G3616 Engines Cylinder Liner - Install
SR4B Generators Coupling - Install
G3612 and G3616 Engines Camshaft - Remove
On-Highway Engines Electronic PTO Installation and Application Guide PTO Parameters - Program
3126B Engines for Caterpillar Built Machines Inlet and Exhaust Valve Seat Inserts - Remove and Install
G3612 and G3616 Engines Camshaft - Install
C-9 Industrial Engine Engine Design