Cooling System Hoses - Inspect
Show/hide table
Illustration 1 | g00359072 |
- Inspect all hoses for leaks due to cracking, for softness next to the clamps, and for loose clamps.
Show/hide table
Illustration 2 | g00403853 |
- Replace hoses that are cracked or soft and tighten any loose clamps.
Use Steps 3.a through 3.g to replace the hoses.
- Slowly loosen the cooling system pressure cap in order to relieve system pressure. Remove the pressure cap.
Show/hide tableIllustration 3 g00402100
- Drain the coolant from the cooling system to a level that is below the hose that is being replaced.
Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on containing fluid spillage.
- Loosen the hose clamps and disconnect the damaged hose.
Note: Dispose of the drained fluids according to local regulations.
- Replace the damaged hose with a new hose.
- Replace the hose clamps and tighten the hose clamps.
- Open the air bleed valve that is located on the coolant line at the top of the engine.
Show/hide tableIllustration 4 g00357912
- Add the appropriate coolant solution to the cooling system. Refer to the Operation and Maintenance Manual, "Cooling System Level - Check" .
- Close the air bleed valve.
- Close the engine hood and latch the engine hood.
Caterpillar Information System:
311B and 312B Excavators Hydraulic System Pressure Specifications - 311B
315B L Excavator Cooling System Coolant Extender (ELC) - Add
315B L Excavator Cooling System Coolant Additive (DEAC) - Add
315B L Excavator Fuel System Secondary Filter - Replace
315B L Excavator Fuel System Priming Pump Strainer - Clean
312B Excavator Attachments General Information
315B L Excavator Fuel System Priming Pump - Operate
301.5, 301.6 and 301.8 Mini Hydraulic Excavators Fire Extinguisher Location
315B L Excavator Engine Oil and Filter - Change
311B and 312B Excavators Hydraulic System Operational Checks - 312B and 312B L
315B L Excavator Engine Oil Level - Check
M312 Excavator Machine System Boom - One Piece
315B and 315B L Excavator Hydraulic System Relief Valve (One Way Flow Line) - Test and Adjust
315B L Excavator Cooling System Level - Check
M312 Excavator Machine System Boom - Stub Boom
315B L Excavator Storage Box
Air Conditioning and Heating R134a for All Caterpillar Machines Refrigerant Accumulator - Remove and Install
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Alternator and Regulator
312B Excavator Attachments Lowering Control Valve (Boom) - Test
M312 Excavator Machine System Boom - Fore Boom
311B and 312B Excavators Hydraulic System Pressure Specifications - 312B and 312B L
312B Excavator Attachments Two-Way Hydraulic Flow Operation
311B and 312B Excavators Hydraulic System Relief Valve (Pilot) - Test and Adjust
301.5, 301.6 and 301.8 Mini Hydraulic Excavators Fuel System Water Separator - Drain