NOTICE |
---|
Mixing Extended Life Coolant (ELC) with other products reduces the effectiveness of the coolant and shortens coolant life. Use only Caterpillar products or commercial products that have passed the Caterpillar EC-1 specification for premixed or concentrate coolants. Use only Caterpillar Extender with Caterpillar ELC. Failure to follow these recommendations could result in the damage to cooling systems components. If ELC cooling system contamination occurs refer to Operation and Maintenance Manual, "ELC Cooling System Contamination" . This machine was factory filled with Extended Life Coolant. |
When a Caterpillar Extended Life Coolant (ELC) is used, an Extender must be added to the cooling system. Refer to Operation and Maintenance Manual, "Cooling Recommendations" for all cooling system requirements.
Check the concentration of the coolant. Use a 8T-5296 Coolant Conditioner Test Kit to check the concentration.
- Unlatch the engine hood and raise the engine hood.
Illustration 1 | g00359072 |
- Open the access door on the left side of the machine.
Illustration 2 | g00393008 |
- Slowly loosen the cooling system pressure cap in order to relieve system pressure. Remove the pressure cap.
Illustration 3 | g00402100 |
- It may be necessary to drain some coolant from the radiator so that Caterpillar Extender can be added to the cooling system.
Note: Dispose of drained fluids according to local regulations.
Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on containing fluid spillage.
- Open the air bleed valve that is located on the coolant line at the top of the engine.
Illustration 4 | g00357912 |
- Add Extender to the cooling system. Refer to the following topics for the proper amount of Caterpillar Extender :
- Operation and Maintenance Manual, "Extended Life Coolant (ELC)"
- Operation and Maintenance Manual, "Refill Capacities"
- Operation and Maintenance Manual, "Extended Life Coolant (ELC)"
- Close the air bleed valve.
- Inspect the gasket of the cooling system pressure cap. If the gasket is damaged, replace the pressure cap.
- Install the cooling system pressure cap.
- Close the engine hood and latch the engine hood.
- Close the left access door.