TRANSMISSION PRESSURE CONTROL VALVE MANIFOLD Caterpillar


TRANSMISSION PRESSURE CONTROL VALVE MANIFOLD

Usage:

TRANSMISSION PRESSURE CONTROL VALVE MANIFOLD

CONFIDENTIAL

TECHNICAL INFORMATION BULLETIN

NOVEMBER 13, 2002

TRACK-TYPE TRACTORS

D6R (7LR1-Up, 2YN1-Up, 9ZS1-Up, 6FR1-Up, 2HM1-Up, 3ZN1-Up, 1RW1-Up, 5PR1-Up, 4FM1-Up, 4MN1-Up, 6MR1-Up, 4WR1-Up, 4JR1-Up, 5LN1-Up, 7GR1-Up, 5RR1-Up, 9BM1-Up, 6JN1-Up, 6HR1-Up, 8XN1-Up, 7KN1-Up, 7DR1-Up, 9MN1-Up, 8LN1-Up, 7ZR1-Up, 4HN1-Up, 9PN1-Up, 4TR1-Up, 8TM1-Up)

D6R II (AEM1-Up, BRJ1-Up, BMK1-Up, BLE1-Up, AGM1-Up, CAD1-Up, BPS1-Up, BMJ1-Up, AAX1-Up, FDT1-Up, BRZ1-Up, BMY1-Up, ACJ1-Up, BPP1-Up, ADE1-Up, BPZ1-Up, BNC1-Up, AEP1-Up, BRE1-Up, DAE1-Up)

D7R (2HR1-Up, 3ZR1-Up, 9HM1-Up, 4SR1-Up, 2EN1-Up, 5MR1-Up, 3DN1-Up, 6ER1-Up, 6GR1-Up)

D7R II (ACS1-Up, BRP1-Up, ADW1-Up, BPK1-Up, AFG1-Up, BRM1-Up, AGN1-Up, BPT1-Up, ABJ1-Up, BNX1-Up)

D8R II (6YZ1-Up, AKA1-Up)

572R (2HZ1-Up, AAC1-Up)

Component Codes: 3065, 3073, 3074, 3083

 

 

SUBJECT: TRANSMISSION PRESSURE CONTROL VALVE MANIFOLD

 

PROBLEM:

Interference may occur between a bolt in the transmission relief valve group and a bolt used to mount the inlet and outlet elbow to the valve group body. See the following illustrations.

Illustration 1

 

Illustration 2

The center bolt (2B-2695) shown as item 12 in illustration 1 may interfere with the center bolt in the transmission relief valve group as shown as item 12 in illustration 2.

 

SOLUTION:

Replaces bolt (2B-2695) with a shorter the bolt (0S-1617).

 

COPYRIGHT 2002 CATERPILLAR

ALL RIGHTS RESERVED

Caterpillar Information System:

Reinforcement Of The Bucket Linkage Assembly Reinforcement Of The Bucket Linkage Assembly
Installation Of The Sitevision GPS Cable Encoder Bracket On Hydraulic Excavators Installation Of The Sitevision GPS Cable Encoder Bracket On Hydraulic Excavators
THE DIAGNOSTIC CODE 175-4 �ENGINE OIL TEMPERATURE SHORT TO GROUND� MAY BE A RESULT OF OVERCOOLING THE DIAGNOSTIC CODE 175-4 �ENGINE OIL TEMPERATURE SHORT TO GROUND� MAY BE A RESULT OF OVERCOOLING
Excessive Clearance Between The Pin Assembly And The Retaining Plate In The Bucket Linkage Excessive Clearance Between The Pin Assembly And The Retaining Plate In The Bucket Linkage
DO NOT USE BLACK RUBBER 173-5576 RING SEALS DO NOT USE BLACK RUBBER 173-5576 RING SEALS
Piston Locknuts for the Stick Cylinder or the Bucket Cylinder May Become Loose Piston Locknuts for the Stick Cylinder or the Bucket Cylinder May Become Loose
The Monitoring System May Lose the Identity of the Selected Tool Name in Display The Monitoring System May Lose the Identity of the Selected Tool Name in Display
REPLACEMENT OF THE FUEL RATIO CONTROL DIAPHRAGM REPLACEMENT OF THE FUEL RATIO CONTROL DIAPHRAGM
Check For Broken Springs In The Hydraulic Control Valve For Complaints Of Hard Engine Starting Or Unexpected Boom Up Movement Check For Broken Springs In The Hydraulic Control Valve For Complaints Of Hard Engine Starting Or Unexpected Boom Up Movement
Updated Predelivery/Revisit Checklists Are Now Used Updated Predelivery/Revisit Checklists Are Now Used
REPORT ALL SUSPECTED DRUM AND DRIVE GROUP COMPONENT FAILURES TO BCP WORK TOOLS PRODUCT SUPPORT REPORT ALL SUSPECTED DRUM AND DRIVE GROUP COMPONENT FAILURES TO BCP WORK TOOLS PRODUCT SUPPORT
Intermittent Air Conditioner Operation Intermittent Air Conditioner Operation
Check The Fuel Transfer Pump Pressure When Fuel Filter Fault Codes Are Displayed On Certain Excavators Check The Fuel Transfer Pump Pressure When Fuel Filter Fault Codes Are Displayed On Certain Excavators
PREMATURE WEAR OF THE CHAIN IDLER GROUP PREMATURE WEAR OF THE CHAIN IDLER GROUP
Service Support Of Certain 320C Excavators Service Support Of Certain 320C Excavators
A NEW INJECTION ACTUATION PRESSURE CONTROL VALVE CONNECTOR INCREASES ENGINE OPERATION A NEW INJECTION ACTUATION PRESSURE CONTROL VALVE CONNECTOR INCREASES ENGINE OPERATION
Flashing New Software When Electronic Control Module (ECM) or Injectors Are Replaced Flashing New Software When Electronic Control Module (ECM) or Injectors Are Replaced
Little or No Heat is Produced by the Heating Unit Little or No Heat is Produced by the Heating Unit
Hydraulic Oil Overcooling Hydraulic Oil Overcooling
MODIFICATION TO PREVENT OIL BLOWING THROUGH THE 165-8460 VENT AS. MODIFICATION TO PREVENT OIL BLOWING THROUGH THE 165-8460 VENT AS.
Engine Speed Hunting on WEX M300C Series Engine Speed Hunting on WEX M300C Series
Automatic Engine Control Regulates Erratically on M300C-Series Wheeled Excavators Automatic Engine Control Regulates Erratically on M300C-Series Wheeled Excavators
Use of the 9Y-5710 Auxiliary Sea Water Pump in 3500 and 3500B applications Use of the 9Y-5710 Auxiliary Sea Water Pump in 3500 and 3500B applications
Check For Clearance When Installing New Electric Starting Motors Check For Clearance When Installing New Electric Starting Motors
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.